Installation Guide
4
WARNING/AVERTISSEMENT
Risk of electrical shock. Only those open holes indicated in the photographs and/or drawings may be made or altered as a result
of kit installation. Do not leave any other open holes in an enclosure of wiring or electric components / Risque de choc électrique.
Seuls les trous ouverts indiqués dans les photos et / ou les dessins peuvent être faites ou modiés à la suite du montage du kit.
Ne pas laisser autres trous ouverts dans l'enceinte du câblage électrique ou composants.
Install End LED Lights
3
• Place proper End LED Light against the face of the mullion near
the two holes drilled at the top.
NOTE: Refer to proper End LED Light orientation depicted in Step 2B.
• Insert a #6-32 x 1/2-inch sheet metal screw into the slot of the
Mounting Tab on the End LED Light, and into the rst hole
that was drilled in the end mullion.
• Use a screwdriver to start threading the screw into the
drilled hole.
• Repeat for the second screw, and for the bottom of the End
LED Light.
• Refer to the manufacturing manual for door frame to ensure
there are no components contained inside the mullion that
could be drilled through. Use a #6 - 3/4-inch self-drilling screw
to attach the End LED Light into one or two of the additional
mounting holes located near the center of the LED Light.
• Refer to wiring diagram on page 6. Connect the red and black
output wires from the LED Light to the red and black wires on the
LED Driver using the twist lock splice wire connectors provided.
End LED Light
Power Leads
Mounting Tab
LED Driver
Output Leads
Wire Wire
EDR
EDL
View from inside case looking out
Identify End LED Light-
Right from Left
2
B
• Verify LEDs are directed towards the center of the case
before installing.
NOTE: Installing the LED Light on the wrong side will result
in very low light level inside the refrigerated case.