Installation Guide

6
Connect LED Driver - Output
For non-dimming applications, cap the unused wires
with 5/32" (4mm) twist on wire connectors.
Bundle and safely secure any unused wires by way of
approved wire ties and wire connectors.
5
Remove the 4-way connector from the LED Driver by
cutting the wires near the connector and strip the output
leads. Using the appropriate wiring diagram on page 5,
connect the LED Driver output leads to the LED Light leads.
Use an ohm meter to identify the two wires connected to the
LED Light that measure between ~ 15,000-18,000 ohms. Use
wire connectors or other connection method approved for low
temperature usage and stranded cable.
• For retrot, place LED driver in the location where the ballast was formerly located.
• Make output (DC) connections using one of the two options below:
USING TWIST-ON WIRE CONNECTORS
A
Connect LED Driver - Input
6
• Make input (AC) connections as noted below:
USING TWIST-ON WIRE CONNECTOR
The LED Driver is required to be reliably bonded to the
protective ground conductor.
Attach the supplied green/yellow ground wire from the
LED Driver to a grounded metal portion of the door frame.
Remove the 3-way connector from the LED Driver by cutting
the wires near the connector and strip the input wires. Using
B
C
• The GEPS6000NCMUL-SY or GEPS6500NCMUL-SY LED Driver is capable of step dimming from 100% power to 20%
power when used with a normally open contact closure occupancy sensor system.
• When using the GEPS6000NCMUL-SY or GEPS6500NCMUL-SY for dimming applications, the slider switch setting must
be set to the right to disable the dimming feature and achieve 100% illumination.
7
Connect Dimming Contacts – Output (Optional)
USING TWIST-ON WIRE CONNECTORS
Remove the 4-way connector from the LED Driver by
cutting the wires near the connector and strip the output
leads. Using the appropriate wiring diagram on page 5,
connect the LED Driver dimming output leads to the
occupancy sensor or control system using wire connectors
or other connection method approved for low temperature
usage and stranded cable.
• To enable dimming operation, connect leads from occupancy sensor or control system (normally open contact) to the purple
and gray leads of the power supply. Other methods, such as using occupancy sensors to switch the LED driver on and off is
not recommended and will void the product warranty.
• Make output (contact closure) connections using one of the two options below:
D
DIMMING
SWITCH
DIMMING SWITCH
Dimming
Dimming Enabled (20%)
Dimming Disabled (default)
the appropriate wiring diagram on page 5, connect the
original Line and neutral wires (or Line 1 and Line 2
wires for 240 nominal VAC) to the LED Driver leads using
the provided twist lock splice wire connectors or other
connection method approved for low temperature
usage and stranded cable.