Installation Guide
• Tuck wires underneath Wire Cover before placing it over the
End Cap and Mounting Tab.
• Attach Wire Cover to LED Light End Cap by installing a
M2.9x10 pan head tapping screw (provided) through the
hole in the End Cap and Mounting Tab using an installation
torque of 3 lbf-in.
NOTE: Tighten slowly until fully seated, do not over tighten or
strip the threads.
• Repeat these steps for the mullion on the other end of the case.
• Using a phillips screwdriver, remove screw and cover from
wire end of LED Light and screw from opposite end of LED Light.
• Electrical connections can be removed to facilitate the
removal of the LED Light.
• Remove the #6-32 x 1/2 inch sheet metal screws that hold
the LED Light to the mullion. Make sure you support the
End LED Light with your free hand.
• Repeat these steps for the mullion on the other end of the case.
Attach Covers to End Cap
Removal Instructions
7
8
CAUTION/ATTENTION
Risk of electrical shock. Plastic cover is needed to protect electrical wires from tampering and accidental contact. / Risque de choc
électrique.Lecouvercleenplastiqueestrequispourassureruneprotectionadéquatecontrel'accèsauxlsetlescontactsaccidentels.
End Cap
Wire Cover
M2.9x10 pan
head tapping
screw
CAUTION/ATTENTION
Risk of electrical shock. Plastic cover is needed to protect electrical wires from tampering and accidental contact. /
Risque de choc électrique. Le couvercle en plastique est requis pour assurer une protection adéquate contre l'accès aux
lsetlescontactsaccidentels.
Wire Cap
7