Installation Guide

Install End LED Lights

• Place proper End LED Light against the face of the mullion near

the two holes drilled at the top.

NOTE: Refer to proper End LED Light orientation depicted in Step 1B.

• Insert a #6-32 x 1/2-inch sheet metal screw into the slot of the

 MountingTabontheEndLEDLight,andintothersthole 

that was drilled in the end mullion.

• Use a screwdriver to start threading the screw into the

drilled hole.

• Repeat for the second screw, and for the bottom of the End

LED Light.

• Repeat these steps for the mullion on the other end of the case.

Make sure the orientation is correct and proper LED Light is used.

• Refer to the manufacturing manual for door frame to ensure

there are no components contained inside the mullion that

could be drilled through. Use a #6 - 3/4-inch self-drilling screw

to attach the End LED Light into one or two of the additional

mounting holes located near the center of the LED Light.

• Refer to wiring diagram on page 5. Connect the red and black

output wires from the LED Light to the red and black wires on the

LED Driver using the twist lock splice wire connectors provided.

End LED Light

Power Leads

Mounting Tab

LED Driver

Output Leads

WARNING/AVERTISSEMENT

Risk of electrical shock. Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of kit

installation. Do not leave any other open holes in an enclosure of wiring or electric components / Risque de choc électrique. Seuls les trous

ouvertsindiquésdanslesphotoset/oulesdessinspeuventêtrefaitesoumodiésàlasuitedumontagedukit.Nepaslaisserautrestrous

ouverts dans l'enceinte du câblage électrique ou composants.

Wire

EDREDL

View from inside case looking out

Identify End LED Light-

Right from Left

• Verify LEDs are directed towards the center

of the case before installing.

NOTE: Installing the LED Light on the wrong

side will result in very low light level inside the

refrigerated case.