Manual

Careand cleaning.
In the Event of a Power Failure
If the power fifils, open the door as
infl'equently as possible to maintain
the temperature. A gradual rise in
temperature should not have any
adverse efl'ect on the wine.
If it is extremely hot, you may want to
(reload the wine fl'om the wine chiller and
move the wine to a cooler location tmtil
power is restored.
When power is restored, the controls
automatically are set to the REDWINE
setting, If needed, reset the controls to
the desired setting.
Preparing to Move
Unload tile wine, then secure tile racks b_ Besure thewine chl//er stays In an upright
taI)ing, them in place to prex ent damab,e posltlonduringthemove.
Replacingthe lightbulb.
Step5:
Removetwo screws
Unplug tile wine chille_:
If tile door is locked, mflock it.
Tile light bulb is located behind a light shield in tile ceiling of tile
wine chiller near tile fl'ont. To remove tile light shield, remove tile
two screws at the back corners of the shield.
Pull down on the back of the light shield to release the two
front tabs.
O Remove tile light bulb housing by removing tile two screws that
attach the housing to the ceiling of the wine chiller.
Pull the bulb out of the receptacle. Replace with a 5 watt, ] 2 volt
bulb. This type of bulb is available at most automotive parts stores.
WARNING:Usinga rate higher,ha,swattsmay amage
the electronic controls on the wine chiller.
O Attach tile light bulb housing to tile ceiling of tile wine chiller with
tile two screws. Make sure not to pinch or damage any of tile wires
attached to the housing.
I,ine up the light shield with the indentation on the ceiling of the
wine chiller, then push tile fl'ont of tile shield up until tile fl'ont tabs
clip into place. Replace the screws at the back of the shield.
O Plug tile wine chiller back in.