Installation Instructions

ManualsBrandsGE ManualsCooking Appliances30 Inch Single Electric Smart Wall Oven with 5.0 Cu. Ft. Capacity, True European Convection with Direct Air, Self-Clean+Steam Clean, No Preheat Air Fry, Precision Cooking Modes, WiFi, UL Listed, Star-K Certified, and ADA Compliant: Left-Hand Side-Swing Do

11A

BOTTOM TRIM INSTALLATION - NON-PEDESTAL,

SWO AND DWO

With oven installed, attach the support bracket to its mounting holes in front vertical brace using

two trim screws provided. Support bracket lip must be placed under flange of bottom air duct.

FINAL INSTALLATION CHECKLIST

• Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced.

• Be sure power is in service to the building.

• Check that all packing material and tape have been removed. Failure to remove these materials

could result in damage to the appliance once the appliance has been turned on and surfaces

have heated.

• Remove all items from inside the oven.

• Check to be sure that the mounting screws are installed and flush with the side trim

(see Section 10).

• Check that the bottom trim is installed properly (see Section 11).

• Ensure that air duct opening at bottom of unit is free of obstructions.

• Check that oven racks function smoothly.

• If applicable - install handles following handle installation instructions and check that both ends are

secured.

OPERATION CHECKLIST

• Turn on the power to the oven (refer to your Owner’s Manual). Verify that the bake and broil

units and all cooking functions operate properly.

• See your Owner’s Manual for the troubleshooting list.

• Be sure all of the oven controls are OFF before leaving the oven.

11B

BOTTOM TRIM INSTALLATION - DWO

With oven installed, attach the bottom trim through its mounting holes in front vertical brace using

two trim screws provided. Bottom trim lip must be placed under flange of bottom air duct.

IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for

service, the bottom trim must be removed first or damage to the trim will occur.

Double Wall Oven Installations

with a Pedestal

IMPORTANT: If this unit is ever removed

from the cabinet or the oven is ever pulled

out for service, the bottom trim must be

removed first or damage to the trim will

occur.

Single and Double Wall Oven

Installations without a Pedestal

Support

Bracket

Screws (x4)

Bottom

Trim

Assembling Support Bracket to Unit After Oven is Installed in Cabinet.

1. Align support bracket hole to the hole on vertical brace.

2. Make sure the tab on the support bracket is tucked under the bottom air duct.

3. Assemble the support bracket to the vertical brace left and right side with the two screws.

Assembling Bottom Trim to the Support Bracket

4. Make sure the bottom trim is setting on top of the support bracket across the entire width of the

part and is not tucked underneath

5. Assemble the bottom trim to the support bracket left and right side with two screws on left and

right.

1. Support Bracket

Hole

2. Tab on Support

Bracket

3. Support Bracket

assembled to Vertical

Brace

5. Support

Bracket

4. Bottom

Trim