Installation guide

Installation Preparation
PREPARE THE OPENING
The Advantium 120 can be installed in combination
with other GE appliances. Always follow each
product's Installation Instructions to complete
the installation.
Single Advantium 120 Installation:
Order a 27"-wide single oven cabinet or cut the
opening in a wall to the dimensions shown.
2_ _ 23-1/2"
n
3
Construct
Base
Hin. 3/8"
Plywood
Supported
by2x4
orlx2
Runners all
Four Sides
• Always maintain 36-3/4" minimum height from
the floor to the cutout in any single or combined
installation.
Allow 111/4 '' case trim overlap at the top and
7/8" overlap on the bottom and each side of the
opening.
Oven overlaps will conceal cut edges on all sides
of the opening.
When installed over a single oven or a warming
drawer, allow at least 2" between the two openings.
This separation will provide clearance for bottom
overlap of the Advantium 220 and the other
appliance overlaps.
Construct a solid oven floor of 3/8" min. thick
plywood supported by 2 x 4 runners on all sides.
The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
PREPARE THE OPENING (CONT.}
Installation over a GE Warming Drawer:
23-1/2"
17-1/2"
W
9-1/4"
36-3/4"
Hin.
4- 25_1/8''_"
Construct
Solid Bottom
Hin. 3/8"
Plywood
Supported
by2x4or
lx 2 Runners
all Four Sides
7_ 2" lVlin
]Jlnstall x or
2 4
2 x 2 Runners
or Solid
Bottom. Hust
Support 100
bs.
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven supports
above the Warming Drawer location do not obstruct
the required interior depth and height. See Warming
Drawer installation instructions for details.