Installation guide

Installation Preparation
Preparation WITHan AccessoryStorage Drawer
NOTE:MODELZSC2202CANNOTBEINSTALLEDWITH AN ACCESSORYSTORAGEDRAWER.SEEINSTALLATIONPREPARATION
WITHOUTAN ACCESSORYSTORAGEDRAWERFORTHISHODEL.
PREPARE THE OPENING
The Advantium 240V can be installed in
combination with other GE/Nonogram appliances.
Always follow each product's Installation
Instructions to complete the installation.
Single Advantium 24OV Installation:
Order a 30" wide single oven cabinet or cut the
opening in a wall to the dimensions shown.
30" _ 23-1/2"
}
I ....
21"
3B-3/4"
Min.
25-I/4"
4- Min* _"
Construct
Base
Min 3/8"
_Plywood
Supported
by 2x4 or 2x2
Runnersall
FourSides
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightly wider,
secure a furring strip on each side of the cutout
for securing the oven.
• Always maintain 36-3//4" minimum height from
the floor to the cutout in any single or combined
installation.
• Allow 3//4" to 2-1/8" case trim overlap on the sides
and 7/8" overlap on the bottom of the opening for
all models. The amount of overlap on the sides
depends on the actual cutout width. Allow 1-1/4"
case trim overlap on the top for models PSB2200
and PSB2201 and 3/4" overlap on the top for
models ZSC2200, ZSC2201 and ZSC2202.
• Oven overlaps will conceal cut edges on all sides
of the opening.
PREPARE THE OPENING {CONT.)
Single Advantium 240V Installation (cont.)
When installed over a single oven or a warming
drawer, allow at least 2" between the two openings.
This separation will provide clearance for bottom
overlap of the Advantium 240V and the other
appliance overlaps.
Construct a solid oven floor of 3/8" min. thick pluwood
supported bu 2 x 4 or 2 x 2 runners on all sides.
• The support must be level and rigidlu mounted,
flush with the bottom edge of the cutout.
Installation over a GE/Monogram
Warming Drawer:
23-1/2" Construct
Solid Bottom
Min. 3/8"
Plywood
Supported
25-I/4" _ by 2x40r 2x2
Min._ / Runnersall
FourSides
2" Min.
(3" recommended)
ig
drawer
requirement
36-3/4"
Min.
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightI9 wider,
secure a furring strip on each side of the cutout
for securing the oven.
NOTE: Additional clearances between the cutouts
mau be required. Check to be sure the oven
supports above the Warming Drawer location do
not obstruct the required interior depth and height.
See Warming Drawer installation instructions for
details.
7