Installation guide

Installation Instructions
[] ROUTE CONDUIT THROUGH
CUTOUT
CAUTION:Two people are required to lift
the oven into the opening. Grasp the bottom at
front and rear. Discard foam base. DO NOT USE
HANDLE OR CONDUIT TO LIFT THE OVEN. DAMAGE
WILL OCCUR.
With oven in front of the cabinet opening:
• Insert conduit into cabinet opening. Connect oven
wiring and branch circuit.
• Lift the oven into the opening while continuing to feed
the conduit in the direction of the installed junction
box. Be sure the conduit does not get pinched
between the back of the oven and the cabinet wall.
• Leave oven a few inches forward of the cabinet
front frame. Do not push the unit all of the wag
into the cutout.
J_
(Ovenshown without
accessorystoragedrawer.)
WARNING
• Disconnect power to the junction box before
making the electrical connection.
• Electrical ground is required on this appliance.
• Do not connect the electrical supplg until
appliance is permanentlg grounded.
GROUNDING INSTRUCTIONS
This appliance must be connected to a grounded,
metallic, permanent wiring sgstem, or an equipment
grounding connector should be run with the circuit
conductors and connected to the equipment
grounding terminal or lead on the appliance.
Failure to follow these instructions could result
in fire, personal injury or electrical shock.
10
[] ROUTE CONDUIT THROUGH
CUTOUT (CONT.)
When connecting to a 3-conductor branch
circuit:
• Connect oven red lead to branch circuit red lead.
• Connect oven black lead to branch circuit black
lead.
• Connect oven green ground lead and white lead
to branch circuit neutral (white or gray).
B C(l_lduc!ol BralIch Cifcdit
Bral/ChCircLlit Overs
!2BVAC Red OC _ Bed
White or
Neutral 6ray _ G/_e/i
h White
12OVAC Black O(_ Back
When connecting to a 4-conductor branch
circuit:
• Connect oven red lead to branch circuit red lead.
• Connect oven black lead to branch circuit black
lead.
• Break connection between oven white lead and
oven green ground lead.
• Connect oven white lead to branch circuit neutral
lead (white or grag).
• Connect oven green ground lead to branch circuit
ground lead (green or bare copper).
4 Conductor Branch Circuit
Brarc (}1c J}t Oven
120VAC Bed C) _ Bed
/20V A(; Back _ Blac
Bareo_
@e_r] C-reen
GND C)_
W/te or (_ray _ White
Neutral
W