Installation guide

Installation Preparation
PreparationWITH an AccessoryStorageDrawer
NOTE:MODELZSC1201CANONLYBEINSTALLEDWITH AN ACCESSORYSTORAGEDRAWERIFINSTALLEDABOVE36-3/4".
MODELZSC1202CANNOTBEINSTALLEDWITHAN ACCESSORYSTORAGEDRAWER.SEEINSTALLATIONPREPARATIONWITHOUT
AN ACCESSORYSTORAGEDRAWERFORTHIS MODEL.
PREPARE THE OPENING {cont.)
The Advantium 12OV can be installed in
combination with other GE/Monogram appliances.
Always follow each product's Installation
Instructions to complete the installation.
Single Advantium 12OV Installation:
Order a 30" wide single oven cabinet or cut
the opening in a wall to the dimensions shown.
25-1/4"___,.
4 .... Min.
21"
36-3/4"
Min.*
\\
\\\
\
\
Construct Base
Min. 3/8" Plywood
"Supported by 2 x 4
or 2 x 2 Runners
all Four Sides
*Requiredfor
Monogrammodels
• Allow 2-1/8" case trim overlap on the sides,
1-1/16" overlap on the top and 7/8" overlap
on the bottom of the opening for all models.
• Oven overlaps will conceal cut edges on all sides
of the opening.
When installed over a single oven or a warming
drawer, allow at least 2" between the two openings.
This separation will provide clearance for bottom
overlap of the Advantium 120V and the other
appliance overlaps.
Construct a solid oven floor of 3/8" min. thick plgwood
supported bg 2 x 4 or 2 x 2 runners on all sides.
The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
PREPARE THE OPENING {cont.)
Installation over a GE/Monogram
Warming Drawer:
23-1/2"
21"
36-3/4"
Min.*
ConstructSolid
BottomMin. 3/8"
f PlywoodSupported
by2x4or2x2
Runnersall FourSides
2" Min.
(3" Recommended)
PerWarming
Drawer
Requirement
×-Requiredfor
Monogrammodels
NOTE: Additional clearances between the cutouts
mag be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth
and height. See Warming Drawer installation
instructions for details.