Installation guide

Installation Preparation
PreparationWITH an AccessoryStorageDrawer
NOTE:MODELZSC1201CANONLYBEINSTALLEDWITH AN ACCESSORYSTORAGEDRAWERIFINSTALLEDABOVE36-3/4".
MODELZSC1202CANNOTBEINSTALLEDWITHAN ACCESSORYSTORAGEDRAWER.SEEINSTALLATIONPREPARATIONWITHOUT
AN ACCESSORYSTORAGEDRAWERFORTHIS MODEL.
PREPARE THE OPENING {cont.)
Installationover a GE/Nonogram Oven:
30" 23-1/2" b
.......................... _ _----- ______
_,-- 25-1Min/4"._____,,.
36-3/4"
Min.
45-1/4"
Recommended
Construct Solid
Bottom Min.
3/8" Plywood
_Supported by
2x4or2x2
Runnersall
Four Sides
2" Min.
(3" Recommended)
PerOven
Requirement
×%quiredfor
Monogrammodels
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightly wider,
secure a furring strip on each side of the cutout
for securing the oven.
, If you are replacing a GE/Monogram electric
double oven with the combined installation
of an Advantium 120V and a single oven, use
the dimensions shown. The middle rail separating
the two openings mag need to be larger than
the 2" minimum shown.
PREPARE THE OPENING {cont.)
Installation over a GE/Monogram Oven and
Warming Drawer:
23-1/2"
ConstructSolid
Bottom Min.
3/8" Plywood
Supportedby
_2x4or2x2
Runnersall
FourSides
2" Min.
(3" Recommended)
PerOven
Requirement
Min.
(3" Recommended)
Drawer Requirement
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightly wider,
secure a furring strip on each side of the cutout
for securing the oven.
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth
and height. See Warming Drawer installation
instructions for details.
.4,CAUTION: Forpersonal safetg, the
mounting surface must be capable of supporting
the cabinet load, in addition to the added weight
of this approximate 80-pound oven and 30-pound
drawer, plus additional oven loads of up to
50 pounds or a total weight of 160 pounds.
10