Installation guide

Installation Preparation
PREPARE THE OPENING
The Advantium 120 can be installed in combination
with other GE appliances. Always follow each
product's Installation Instructions to complete
the installation.
Single Advantium 120 Installation:
Order a 27"-wide single oven cobinet or cut the
opening in a wall to the dimensions shown.
23-1/2"
Construct
Base ,
Min. 3/8'
Plywood
\\ Supported
by2x4
or1 x2
Runnersall
FourSides
• Always maintain :36-3/4" minimum height from
the floor to the cutout in ang single or combined
installation.
• Allow 1-1/4" case trim overlop tit the top and 7/8"
overlop on the bottom and each side of the
opening.
• Oven overlops will conceal cut edges on all sides
of the opening.
When installed over a single oven or a warming
drawer, allow at least 2" between the two openings.
This separation will provide clearance for bottom
overlap of the Advantium 120 and the other
appliance overlaps.
Construct a solid oven floor of 3/8" rain. thick
plgwood supported bg 2 x 4 runners on all sides.
• The support must be level and rigidlg mounted,
flush with the bottom edge of the cutout.
PREPARE THE OPENING (CONT.}
Installation over a GE Warming Drawer:
27" -- 23-1/2"
17-1/2"
W
9-1/4"
36-3/4"
Min.
.,,_ 25_1/8''_"
J
I
Construct
SolidBottom
Min. 3/8"
Plywood
Supported
by2x4or
1x 2 Runners
all FourSides
2" Min.
Install2x4 or
__)[ 2x2Runners
orSolidBottom.
MustSupport
100Ibs.
NOTE: Additionol cleorances between the cutouts
may be required. Check to be sure the oven supports
above the Warming Drawer location do not obstruct
the required interior depth and height. See Warming
Drawer instc_llation instructions for details.