Installation guide

Installation Preparation

ELECTRICAL REQUIREMENTS

Single Advantium 120 Installation:

This product requires a 120-volt, 60 Hz, 15-amp circuit

and draws 1.8 kilowatts. This product must be

connected to a supply circuit of the proper voltage

and frequency.

• Wire size must conform to the requirements of the

National Electrical Code or the prevailing local code

for this kilowatt rating.

• The power supply cord and plug should be brought

to a separate 15- or 20-ampere branch circuit single

grounded receptacle. The outlet box should be

located within reach of the 48" power cord.

ELECTRICAL LOCATION

Locateoutlet box in the shaded area

Install a recessed electrical outlet in the back wall

of the opening within 6" of either side and at least

9" above the cutout floor.

IMPORTANT: (Please read carefully).

The power cord of this appliance is equipped with

a three-prong (grounding) plug that motes with

a standard three-prong grounding wall receptacle

to minimize the possibility of electric shock. The

customer should have the wall receptacle and circuit

checked bg o qualified electrician to make sure the

receptacle is properlg grounded and has the correct

polaritg.

• Where o standard two-prong wall receptacle is

encountered, it is the personal responsibilitg and

obligation of the customer to hove it replaced with

a properly grounded three-prong wall receptacle.

Do not, under ang circumstances, cut or remove

the third (ground) prong from the power cord.

DO NOT USE AN EXTENSION CORD.