Installation guide

ManualsBrandsGE ManualsMicrowaveOfficial GE microwave

tallati

structi

Profile Advantium TM 120 Built-ln

SpeedCook Ovens

PSB1000 PSB1001

Questions? Call800.GE.CARES (800.432.2737)orvisitour Website at:GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completelg

and carefullg.

• IMPORTANT- Savetheseinstructions

for local inspector's use.

• IMPORTANT- Observeallgoverning

codes and ordinances.

• Note to Installer- Be sure to leave these

instructions with the Consumer.

• Note to Consumer - Keep these instructions for

future reference.

• Skill level -Installation of this appliance requires

basic mechanical and electrical skills.

• Completion time- 1 hour

• Proper installation is the responsibility of the

installer,

• Product failure due to improper installation is not

covered under the Warranty, See Owner's

Manual for warranty information.

IMPORTANT:

• Use this oven only for its intended purpose,

• Never use the oven for warming or heating a

room, Prolonged use of the oven without proper

ventilation can be hazardous,

-&CAUTION:

For personal safetLI, remove house fuse or oven

circuit breaker before beginning installation to avoid

severe or fatal shock injurLI.

-_ CAUTION:

For personal safetLI, the mounting surface must be

capable of supporting the cabinet load, in addition

to the added weight of the 7S-pound product, plus

additional oven loads of up to 50 pounds or a total

weight of 125 pounds.

-&CAUTION:

For personal safetg this product cannot be

installed in cabinet arrangements such as an island,

a peninsula or below a countertop.

For a Spanishversion ofthis manual,

visit our Websiteat GEAppliances.com.

Para consultar una version enespafiol

deestemanual deinstrucciones,visite

nuestro sitio deinternet GEAppliances.com.

CONTENTS

Design Information

Models Available ....................................................................2

Product Dimensions and Clearances ..........................2

Tools Required ........................................................................2

Parts Supplied ........................................................................2

Advance Planning ................................................................3

Installation Instructions

Step 1, Slide the Oven into the Cutout ........................7

Step 2, Install Bottom Trim ................................................7

Step 3, Install Mounting Screws ......................................8

Step 4, Finalize Installation ................................................8

Installation Preparation

Electrical Requirements ....................................................4

Prepare the Opening ......................................................5, 6

Remove the Packaging ......................................................6

PIFL59060902 49-40607 02-09 JR

Summary of content (16 pages)

PAGE 1
Profile Advantium 120 Built-ln SpeedCook Ovens I tallati I structi TM PSB1000 PSB1001 Questions? Call800.GE.CARES (800.432.2737)or visitour Website at:GEAppliances.com BEFORE YOU BEGIN Read these instructions and carefullg. -&CAUTION: completelg • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe allgoverning codes and ordinances. • Note to InstallerBe sure to leave these instructions with the Consumer. • Note to Consumer future reference.
PAGE 2
Design Information MODELS AVAILABLE Profile Models: PSBIOOOWW - White PSBIOOOBB - Black PSBIO01SS - Stainless Steel PRODUCT DIMENSIONS AND CLEARANCES 26-3/4" \ ] \ \ \ \ I 13" _'_ 1-1/16" NOTE: Appearance may vary slightly by model.
PAGE 3
Design Information ADVANCE PLANNING • These ovens mag be installed directlg into a 27'Lwide oven cabinet. • The oven must be installed at least 36-3/4" above the floor. • The front surface of the oven will be nearlg flush with surrounding cabinetrg doors. • Allow for clearance drawers, etc. • This oven can be installed over ang GE single electric built-in oven or a warming drawer or both. • Cabinets installed adjacent to wall ovens must have an adhesion spec of at least 194% temperature rating.
PAGE 4
Installation Preparation ELECTRICAL REQUIREMENTS Single Advantium 120 Installation: This product requires a 120-volt, 60 Hz, 15-amp circuit and draws 1.8 kilowatts. This product must be connected to a supply circuit of the proper voltage and frequency. • Wire size must conform to the requirements of the National Electrical Code or the prevailing local code for this kilowatt rating. • The power supply cord and plug should be brought to a separate 15- or 20-ampere branch circuit single grounded receptacle.
PAGE 5
Installation Preparation PREPARE THE OPENING PREPARE THE OPENING (CONT.} The Advantium 120 can be installed in combination with other GE appliances. Always follow each product's Installation Instructions to complete the installation. Installation Single Advantium over a GE Warming 27" -- Drawer: 23-1/2" Construct Solid Bottom Min. 3/8" Plywood Supported 120 Installation: Order a 27"-wide single oven cobinet or cut the opening in a wall to the dimensions shown. .
PAGE 6
Installation Preparation PREPARE THE OPENING (CONT.) PREPARE THE OPENING (CONT.} installation overa GE Oven: installation Drawer: Construct Solid Bottom Min. 3/8" Plywood Supported by 2x4or1 x2 Runners all Four Sides over a GE Oven and Warming ConstructSolid 27"-- 23-1/2" Bottom Min. 3/8" Plywood Supportedby 2x4orlx2 Runnersall Four Sides 25-1/8" 2" Min. MJn.
PAGE 7
installation [']'] SLIDE THE OVEN INTO THE CUTOUT CAUTION: Two people are required [] INSTALL BOTTOM TRIM • Align bottom trim tabs to slots in the bottom of the oven. to lift the oven into the opening. Grasp the bottom at the front and rear. DO NOT USE THE HANDLE TO LIFT THE OVEN. DAMAGE WILL OCCUR! i n Secure the bottom trim to the bottom using 3 brass screws provided. • Lift and hold the oven at the front of the opening. Hold the oven at a 45 ° angle and plug in the power cord.
PAGE 8
installation [] INSTALL MOUNTING SCREWS [111113O CE13CEEID CEEE] CEEE] CEE_ [ZE3 J • Drill pilot holes through side. • Drive the color-matched the side flanges, 2 on each screws into the side flange. [_ FINALIZE INSTALLATION • Turn the power on at the source. The interior light should come on when the door is opened. Refer to the Owner's instructions.
PAGE 9
I de Profile Advantium 120 Hornos empotrados SpeedCook TM ® tr I CCl stol ® PSB1000 PSB1001 tiPreguntas?Llame al800.GE.CARES (800.432.2737)o bien visitenuestra p6gina Web: GEAppliances.com ANTES DE INICIAR Lea estas instrucciones g cuidadosamente. -_ PRECAUCI6N: completa • IMPORTANTE - Guarde estas instrucciones para uso del inspector • IMPORTANTE local. - Observe todos losc6digos g 6rdenes de leg. • Nota alinstalador - Aseg0rese de dejar estas instrucciones con el consumidor.
PAGE 10
Informaci6n sobre el dise5o MODELOS DISPONIBLES Modelos Profile: PSBIOOOWW- Blanco PSBIOOOBB - Negro PSBIO01SS - Acero inoxidable DIMENSIONES DEL PRODUCTO Y ESPACIO LIBRE 26-3/4" 22-9/16" _ 21-1/2" 1-1/8" "1 \ ] \ \ \ \ 18-5/8" ] 13"-U_ 1-1/16" 13/16" NOTA: La apariencia puede variar levemente de modelo a modelo. HERRAMIENTAS NECESARIAS PARTES INCLUIDAS • Destornillador • 6 tornillos de lat6n (3 necesarios, 3 adicionales) Phillips N.
PAGE 11
Informaci6n sobre el dise5o PLANIFICACI6N ANTICIPADA • Estos hornos pueden instalarse directamente en alacenas para homo de 27" de ancho. • El horno debe instalarse del piso. • La superficie delantera del horno quedar6 casi al mismo nivel que las puertas de las alacenas circundantes. • Deje espocio libre para esquinas, paredes, cajones adgocentes, etc. • Este horno puede instalarse sabre cualquier horno empotrado individual GE o sabre un caj6n calentador, o ambos.
PAGE 12
Preparaci6n para la instalaci6n REgUISITOS ELI_CTRICOS Instalaci6n 6nica del Advantium 120: Este producto requiere un circuito de 120 voltios, 60 Hz, 15 amp g toma 1.8 kilovatios. Este producto debe conectarse a un circuito de alimentaci6n del voltaje g la frecuencia adecuados. • El tama_o del cable debe respetar los requisitos del C6digo EI6ctrico Nacional (National Electrical Code) o el c6digo local en vigencia para esta potencia de kilowatios.
PAGE 13
Preparaci6n para la instalaci6n PREPARE LA ABERTURA PREPARE LA ABERTURA ICONT.I El Advantium 120 puede instalarse en combinaci6n con otros aparatos GE. Siempre siga las indicaciones de instalaci6n de cada producto para realizar la instalaci6n. Instalaci6n sobre un caj6n calentador GE: Instalad6n 6nica del Advantium 120: 2__ C0nstruya unabase inferiorsOtida demadera c0ntrachapada dem[n.
PAGE 14
Preparaci6n para la instalaci6n PREPARE LA ABERTURA (CONT.} PREPARE LA ABERTURA Instalaci6n sobre un homo GE: Instalaci6n calentador 25-1/8" (CONT.) sobre un homo y un caj6n GE: Construyauna base inferior sOlidade rain, 3/8", sostenida por correderas de2x46 1 x 2 en los cuatro lados Construya una base inferior sOlida de mFn. 3/8", sostenida por correderas de2x46 1 x 2 en los cuatro lados Min.
PAGE 15
Instalaci6n m DESLICE EL HORNO DENTRO DEL CORTE PRECAUCION: Serequieren [_] INSTALE EL RECORTE INFERIOR • Alinee los lengQetas del recorte inferior con los ranuras de la porte inferior del homo. dos personas poro levontorelhorno e introducirlo en Ioabertura.Agorre Ioparte inferior par delante g par detr_s.NO USE LA MANIJA PARA LEVANTAR EL HORNO. iPUEDE DANARSE! mj • Ajuste el recorte inferior del horno usando los 3 tornillos de metal incluidos. L • Levante g sostenga elhorno delante de laabertura.
PAGE 16
Instalaci6n [_] INSTALE LOS TORNILLOS DE MONTAJE _Q EZID CZZ] [ZZZZ] [11111113[11111113(11113 D • Realice orificios piloto con el taladro en los salientes laterales, 2 de cada lado. • Coloque los tornillos de color combinado en el saliente lateral. [_] FINALICE LA INSTALACI6N • Conecte la energia en la fuente. La luz interior se encender6 al abrir la puerta. • Consulte el Manual del propietario para obtener instrucciones acerca de c6mo operar el homo.