Specification

Specification Created 4/21
PSA9120SP
GE Profile Series Over-the-Range Oven with Advantium
®
Technology
HOOD EXHAUST DUCT
Outside ventilation requires a HOOD EXHAUST DUCT. Read the following
carefully.
EXHAUST CONNECTION:
The hood exhaust has been designed to mate with a standard 3-1/4" x 10"
rectangular duct.
If a round duct is required, a rectangular-to-round transition adaptor must be
used. Do not use less than a 6” diameter duct.
REAR EXHAUST:
If a rear or horizontal exhaust is to be used, care should be taken to align
exhaust with the space between studs, or wall should be prepared at the time it
is constructed by leaving enough space between the wall studs to accommodate
exhaust.
MAXIMUM DUCT LENGTH:
For satisfactory air movement, the total duct length of 3-1/4" x
10" rectangular or 6” diameter round duct should not exceed 140
equivalent feet.
ELBOWS, TRANSITIONS, WALL AND ROOF CAPS, etc.,
present additional resistance to airflow and are equivalent to a
section of straight duct which is longer than their actual physical
size. When calculating the total duct length, add the equivalent
length of all transitions and adaptors plus the length of all straight
duct sections. The chart below shows the approximate feet of
equivalent length of some typical ducts.
Grille
FILTER KIT ACCESSORY
Filter Kit
JX81D–Recirculating
Charcoal Filter Kit
To be used when
the Advantium oven
cannot be vented
to the outside.
DIMENSION INFORMATION (IN INCHES)
DUCT EQUIVALENT
A. Rectangular-To-Round 5 Ft.
Transition Adaptor
B. Wall Cap 40 Ft.
C. 90° Round Elbow 10 Ft.
D. 45° Round Elbow 5 Ft.
E. 90° Rectangular Elbow 25 Ft.
F. 45° Rectangular Elbow 5 Ft.
G. Roof Cap 24 Ft.
Listed by
Underwriters
Laboratories