Specification

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
PP9830SR
GE Profile
™
Series 30" Downdraft Electric Cooktop
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Specification Revised 8/22
Listed by
Underwriters
Laboratories
WALL INSTALLATION: Wall installations require
25" countertop depth. When cabinet is flush against
the wall, the fan housing can be rotated to the
horizontal position for direct venting through rear
wall. Make a countertop cutout in the range cabinet
according to unit dimensions and installation type.
Duct hole is positioned in back of cabinet for
through-the-wall ducting.
PENINSULA OR ISLAND INSTALLATION: For
peninsula/islands a minimum 26" countertop depth
is suggested. Blower should be in vertical position.
Island or peninsula cabinets may require adjustment
in cutout depth and/or location within the width
dimensions. Duct hole is positioned in bottom of
cabinet for island or peninsula installation.
SLAB INSTALLATION: For peninsula or island
installation and rear wall ducting, 6" PVC duct or
locally approved piping should be used if installing
under a poured concrete slab.
RECEPTACLE LOCATION: Install an approved
junction box within shaded area shown in diagram.
Junction box must be at least 10-1/2" below top
of cabinet.
INSTALLATION INFORMATION: Before installing,
consult installation instructions, packed with product,
for current dimensional data.
NOTE: Electrical cable is not supplied with unit.
Order part number JXCK89 from your Ge
Appliances Dealer. These cooktops are approved for
indoor use only
*Note: A 6" minimum spacing to adjacent side wall is
required Dimension and installation information a
re shown in inches.
KW RATING
240V 9.1
208V 6.9
APPROXIMATE COOKING DIMENSIONS
*U.L. Requirement
Note: A 5" minimum spacing to adjacent side wall is required
29-3/4"
(29-13/16" SS)
28-3/4"
21-7/8"
(21-15/16" SS)
2-3/16"
(2-1/4" SS)
22"
20-1/2"
11-1/2"
20-5/8"
28-7/8"
25"
1-7/8"
MIN. Required*
Cut-out Dimensions (in inches)