Specification

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
PHP9030DT
GE Profile
™
30" Built-In Touch-Control Induction Cooktop
For answers to your Monogram, GE Café
™
, GE Profile
™
or GE Appliances
product questions, visit our website at geappliances.com or call
GE Answer Center
®
Service, 800.626.2000.
ADA
COMPLIANT
Listed by
Underwriters
Laboratories
Specification Revised 10/22
29-3/4"
1-3/4" MIN.
to rear wall
19-1/4"
19-5/8" to
19-3/4"
28-1/2"
to 28-5/8"
2-1/2" MIN.
Required
Cooktop
To insure accuracy, it is best to make a
template when cutting the opening in the counter
21"
28-1/16"
13" MAX. depth of unprotected
overhead cabinets
2" MIN. Clearance
from cutout to nearest
vertical wall or cabinet
on right side of the unit
below the 15" MIN.
clearance height.
15" MIN. height
from countertop
to nearest cabinet
(including light rails)
on both sides of
cooktop
30" MIN. Clearance from
countertop to unprotected
overhead surface
See label next
to nameplate for
MIN. clearance
to rear wall.
2" MIN. clearance
to side wall from cut-out
on the left of the unit
4-5/8" at baffle near center
of unit (except when installed
above an approved wall
oven) and 3-1/4" at rear
of air intake
IMPORTANT: Requires a 3" free area between the
bottom of the cooktop to any combustible material,
i.e., shelving. Free area not required when installing
wall oven underneath cooktop. Refer to installation
instructions. Requires a 15" minimum from cooktop
to adjacent overhead cabinets. Units are furnished
with a 48" flexible armored cable.
NOTE: 30" induction cooktops are approved for
use over select GE 27" and GE 30" Single Wall
Ovens and Warming Drawers. Refer to cooktop and
wall oven/warming drawer installation instructions
packed with product for current dimensional
data. If installed with a GE Telescopic Downdraft
System, consult both the cooktop and downdraft
installation instructions packed with product before
installing. Cooktop gas/electric supply may need to
be re-routed to install downdraft. The countertop
cutout requires 23-1/2” minimum flat countertop
surface and 25” minimum total countertop depth.
In addition, other clearances to front edge of the
countertop must be considered. Before installing,
consult installation instructions packed with
product for current dimensional data.
CUTOUT FILLER TRIM KIT: A filler trim kit is
available for use if your countertop cutout is
larger than the dimension shown, up to 29-13/16"
x 20-7/16". Order JXTR32B for black or JXTR32W
for white, to reduce the cutout opening for
installation of this cooktop. These kits may be
ordered from your GE Appliances Dealer.
APPROXIMATE COOKING DIMENSIONS
KW R ATING
240V 7.7
208V 6.9
AMPERAGE
240V 40 Amps
†
208V 40 Amps
†
†
NOTE: Check local
codes for required
breaker size.
2-1/2" MIN
From front edge
of countertop to front
edge of cooktop cutout
31-1/4" MIN
From top surface
of countertop to
top surface of
wall oven support
platform
INSTALLATION ABOVE A WALL OVEN
INSTALLATION ABOVE A WALL OVEN