How To Guide

If any installation parts for your gas downdraft
cooktop are missing or defective, call GE Parts
at 800.626.2002 and we will send replacement
parts directly to you.
Please do not call GE Consumer Service to
schedule a service call for replacement parts.
Thank you and enjoy your new cooktop!
PGP989—Unpack Your Cooktop
PARTS INCLUDED (packed below the cooktop)
• Blower assembly
• Mounting nuts (4)
(10-32 keps—nuts with
lock washers attached)
• Blower plenum
• Burner grates (2)
• Reflective tape
• Sheet metal screws (9)
(8-18 x 3/8″)
• Foam gasket tape (9 ft. roll)
• Vent filter
• Vent grille
• Vent grille gasket
• Cleaning cream
• Scrub sponge or scraper
(on some models)
• Gas pressure regulator &
LP Conversion Instructions
• Burner heads (1 small [A],
2 medium [B], 1 large [C])
• Burner caps (1 small [A],
2 medium [B], 1 large [C])
• 120V grounded plug cord
(attached)
Vent grille
Cleaning cream
(WX10X300)
Sheet metal
screws (9)
(8-18 x 3/8″)
Foam gasket tape
(9 ft. roll)
Blower assembly and mounting nuts (4)
(10-32 keps—nuts with lock washers attached)
Blower plenum
Vent filter
Gas pressure regulator
Burner grates (2)
Vent grille
gasket
49-80518
06-08 JR
Reflective Tape
Medium
burner cap (2)
Medium
burner head (2)
Large burner head
Small burner cap
Small burner head
Large burner cap
CAUTION: GLASS IS FRAGILE. DO NOT
BUMP EDGE OF GLASS DURING INSTALLATION.
Scrub sponge
or scraper
(on some models)
CAUTION:
DO NOT LIFT FROM
VENT OPENING OR
BUMP GLASS
Check to be sure that all packing
materials and tape have been
removed. This will include tape on
control knobs (if applicable), adhesive
tape, wire ties, cardboard and
protective plastic. Failure to remove
these materials could result in
damage to the appliance once the
appliance has been turned on and
surfaces have heated.