Product Brochure

8. CONFIRM OPERATION WITH COMBO
▪ Try running a quick RINSE & SPIN to
confirm that water is being supplied to
the Combo at the temperature you
selected at the faucet.
9. SET THE WASHER CONTROLS
▪ Select your desired cycle and options.
Regardless of whether you select
Tap Cold, Cold or Warm, the Combo
will use the water at the temperature
supplied by the faucet.
▪ For cycles requiring
Hot or Ex. Hot
water like the
Sanitize cycle, the
Combo will alert
you that you must
adjust the water
temp at the sink.
UNICOUPLER (continued)
GE PROFILE UltraFast Combo Accessories Guide | www.geappliances.com | 9
4. CONNECT TO COLD VALVE INLET
Note: Unplug electrical cord before
installing water hose.
▪ If not installed, install rubber washer in
one end of cold water.
▪ Thread COLD
water hose onto
the BLUE
connection
(right side).
NOTE: Only the
cold valve will be
connected for this
installation.
Hot valve should NOT be connected.
▪ Hand tighten and use pliers to tighten
hoses between 1/8 and 1/4 turn beyond
hand tight.
5. INSTALL CAP ON HOT VALVE
▪ Install and
tighten
cap on hot
water valve
inlet to
prevent
water from
leaking
from this
connection.
7. SLOWLY TURN ON THE WATER AT THE
FAUCET ALL THE WAY TO THE DESIRED
WASH TEMPERATURE
ERROR
Confirm H2O Supply is
ON
Fault Code: 8
Dismiss