Installation guide

ManualsBrandsGE ManualsDishwasherOfficial GE dishwasher

L_LJI_cL!_'" c- l?r_ qr ¢iI

.... lt!_F ,":,' _ .................

Appliances

Installation instructions

Built-in Dishwasher

If gou have questions, call 800.GE.CARES (800.432.2737} or visit our website at: www.ge.com

BEFORE YOU BEGIN

Read these instructions completely and

carefully.,

IMPORTANT- Observe all governingcodes and

ordinances

• Note to Installer - Be sure to leave these instructions for the

consumer's and local inspector's use

• Note to Consumer - Keep these instructions with gour

Owner's Manual for future reference,

• Skill Level - Installation of this dishwasher requires

basic mechanical, electrical and plumbing skills Proper

installation is the responsibilitg of the installer° Product

failure due to improper installation is not covered under

the GE Appliance Worruntgo See warranty information

• Completion Time - ! to 3 Hours New installations require

more time than replacement installations

IM PORTANT- ThedishwasherMUST

be installed to allow for future removal from the enclosure

if service is required,

tf gou received o damaged dishwasher, gou should

immediatelg contact gout dealer or builder

Optional Accessories - See the Owner's Manual for available

custom panel kits

FOR YOUR SAFETY

Read and observe all CAUTIONS and WARNINGS

shown throughout these instructions° While performing

installations described in this booklet, gloves and either

safety glasses or goggles should be worn,

READ CAREFULLY.

KEEPTHESE INSTRUCTIONS.

imagination at work

Summary of content (12 pages)

PAGE 1
L_LJI_cL!_'" .... lt!_F c- _ l?r_ qr ¢iI ,":,' ................. Appliances Installation instructions Built-in Dishwasher If gou have questions, call 800.GE.CARES (800.432.2737} or visit our website at: www.ge.com BEFORE YOU BEGIN IM PO RTANT- The dishwasher MUST Read these instructions carefully.
PAGE 2
Installation Preparation PARTS SUPPLIED: [] Two #8 Phillips head wood screws. 5/8" !ong to secure dishwasher to underside of countertop (in literature package) MATERIALS [] YOU WILL NEED: Ferrule. compression nut and 90 ° Elbow (3/8" NPT external thread on one end.
PAGE 3
Installation Preparation PREPARE DISHWASHER The dishwasher must be installed so that drain hose is no ENCLOSURE more than 10' in length for proper droiqage.
PAGE 4
Installation Preparation PREPARE ELECTRICAL WIRING _,2 | I _ l II I FOR PERSONAL SAFETY: S Remove house fuse or open circuit breaker before beginning installation Do not use on extension cord or adopter plug with this appliance ./. -- I ...... Electrical Requirements • This appliance must be supplied with 120V.
PAGE 5
Installation Instructions PREPARE HOT WATER LINE BEFORE YOU BEGIN • The line may enter from either side.
PAGE 6
Installation Instructions STEP 2 ADJUST LEVELING LEGS • Move the dishwasher dose to the installation it on its back STEP 4 INSTALL POWER CORD location and lag Skip this step if dishwasher will be direct wired° Use Power Cord Kit WXO9X70910. available for purchase from an authorized GE Appliance Dealer..The power cord and connections must complg with the National Electrical Code, Section 422 and/or local codes and ordinances. • Maximum power cord length is 6'.
PAGE 7
Installation Instructions STEP 6 POSITION WATER LINE AND HOUSE WIRING STEP 8 SLIDE DISHWASHER • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher DO NOT PUSH AGAINST FRONT PANEL WITH KNEES_ DANAGE WILL OCCUR ° Slide dishwasher into the opening a few inches at a time INTO CABINET o Not Push Against Front Door Panel With Knee. Damage to The Door Panel Will Occur.
PAGE 8
Installation STEP 9 POSITION instructions DISHWASHER UNDER _g P_rS_t_ pnngDi_ho_!h Qsher COUNTERTOP • Push the dishwasher into the cabinet ° Push the sides with gour hands Do not use gour knee against the door since door damage will occur.
PAGE 9
Installation Instructions STEP 11 SECURE DISHWASHER TO COUNTERTOP OR CABINET STEP 10 LEVEL DISHWASHER IMPORTANT- Dishwasher must be level for proper dishrockoperationend wash performance.
PAGE 10
Installation Instructions STEP 12 CONNECT DRAIN LINE INSTALLATION WATER SUPPLY Connect water supptg line to 90 ° elbow, o glide compression nut, then ferrule over end of ..--J J Compression Nut "'-\ water line x --._ • Insert water Fineinto 90 ° // i JFerrule -_ elbow, • Slide ferrule against elbow and secure with compression \'"' nut Figure BB • Connect drain line to air gap, waste tee or disposer using either previouslg determined method Method 1 - Air gap with waste tee or disposer Insert the d
PAGE 11
Installation Instructions STEP 14 CONNECT POWER SUPPLY STEP 15 PRETEST CHECK LIST Skip this step if equipped with power cord, Verify that power is turned off at the source_ , Remove junction box cover W' Review this Fist after installing gour dishwasher to avoid charges for o service cell that is not covered by gour warranty, • Locate the three dishwasher wires, twhite, black and green) with stripped ends Insert dishwasher wires through the small hale in the junction box "B" • Secure house wiring to
PAGE 12
Installation Instructions STEP 16 DISHWASHER WET TEST STEP 17 REPLACE TOEKICK [] Turn on power supply (or plug power cord into outlet, if equipped} [] Start the unit to check for leaks - Press ON!OFF button to turn unit on - Press CYCLE SELECTbutton until light below RINSE cgcle illuminates [] Close door [] Check to be sure that water enters the dishwasher If water does not enter the dishwasher, check to be sure that water and power are turned on [] Check for leaks under the dishwasher If a leak