Brochure

GE Inspection Technologies

Xray

SEIFERT WL 3001

Wasserkühlpumpe

The WL 3001 cooling aggregate has been

designed to dissipate anode heat from the

X-ray tube if, for economic or technical

reasons, direct cooling from a water sup-

ply system is impracticable.

The cooling medium can be water or a

water-glycol blend. The water circulates

between the cooling unit and the heat

source. It is recooled by a air-cooled heat

exchanger.

The maximum cooling output depends on

the difference between the temperature

at the water inlet and the temperature

at the cooling water inlet. It amounts

3000 W at the temperature difference of

11,5 K between water outlet- and ambient

temperature.

A thermostat switch is monitoring the

temperature of the cooling water.

Application

PAGE 1
GE Inspection Technologies Xray SEIFERT WL 3001 Wasserkühlpumpe Application The WL 3001 cooling aggregate has been designed to dissipate anode heat from the X-ray tube if, for economic or technical reasons, direct cooling from a water supply system is impracticable. The cooling medium can be water or a water-glycol blend. The water circulates between the cooling unit and the heat source. It is recooled by a air-cooled heat exchanger.
PAGE 2
Xray GE Inspection Technologies Description The cooling output depends on the ambient temperature, on the temperature of the return-ﬂow cooling water, and also on the ﬂow rate. In practice, the cooling capacity of the WL 3001 at up to 25°C ambient temperature is sufﬁcient for continuous operation (100% duty cycle) of X-ray tubehousings (up to 3000 W).