Technical Specifications

ValVue Digital Communications Software Ver. 2.80
82
GE Oil & Gas
measurements, the D/A value of the signal to the I/P, and the internal SVI II AP
temperature.
 143 Read Temperatures – Reads the historical low and high range to which the
positioner was be exposed and reads the actual circuit board temperature
 201 Read All Pressures – Reads the Actuator, Supply and IP pressure (available with the
Advanced Diagnostics version)
 249 Read Operating Mode – Reads and displays the positioner operating mode.
Setup Wizard
Running the Setup Wizard is one of two ways to set up the SVI II AP. When you decide to run
the setup you can either run the entire wizard or pick and choose which components to run.
From the Setup Wizard screen you can rapidly setup the SVI II AP by configuring some basic
parameters. By selecting the appropriate check boxes you can set the device identification,
select the air action, perform a travel calibration, and autotune the positioning parameters.
When the selected tasks are started, ValVue displays a progress screen.
To customize the valve setup refer to “Advanced Setup with ValVue” on page 57 of this
manual.
Figure 56 Starting the Setup Wizard
Setup Wizard Button