Technical Specifications

ValVue Digital Communications Software Ver. 2.80
76
GE Oil & Gas
Changing the Setpoint
To change the manual setpoint the SVI II AP must be in manual mode. There are three ways to
change the position indicator:
1. Entering the setpoint value in the Setpoint dialog.
2. Dragging the position indicator.
3. Left clicking on either side of the position indicator modifies the setpoint by 5%.
Figure 49 Position Indicator Active
Entering Setpoint Value
To enter a value for the position indicator setpoint:
1. Right-click inside the position indicator area and Figure 50 appears.
2. Enter the setpoint percentage and click OK.
Figure 50 Changing Position Indicator
Position Indicator Active (Manual Mode)