Technical Specifications

ValVue Digital Communications Software Ver. 2.80
650
GE Oil & Gas
$$SignalUnits - the signal units (always mA)
$$Language - SVI display language
$$LowSignal - Low calibration value
$$HighSignal - High calibration value
$$P - Proportional gain in positioner
$$Padjust - Adjustment to P when valve is exhausting
$$I - Integral action of positioner
$$Beta - Step size adjustment in positioner
$$D - Derivative action of positioner
$$PosComp - Position range compensation of positioner
$$DeadZone - Dead zone of positioner
$$Damping - Damping coefficient of positioner
$$Travel - Total strokes of the valve
$$Cycles - Total cycles of the valve
$$TimeOpen - Total time open of the valve
$$TimeClosed -Total time closed of the valve
$$TimeNearClosed - Amount of time valve was nearly closed
$$ResponseOpen - Time require to open valve
$$ResponseClosed - Time required to close valve
$$Switch1Type - The condition under which switch 1 operates
$$Switch1Value - The value at which switch 1 activates
$$Switch1Action - Switch is normally closed or normally open
$$RawSignal - The signal value in A/D counts
$$RawPosition - The position value in A/D counts
$$PositionStopLow - The position A/D counts at the lower stop
$$PositionStopHigh - The position A/D counts at the upper stop
$$OptionConfig - Data describing the hardware installed on the positioner
$$OptionConfigEx0, $$OptionConfigEx1, $$OptionConfigEx2, $$OptionConfigEx3 - Data
describing the hardware installed on the positioner