Technical Specifications

401
Damping
Advanced Setup
Damping
The Damping Time is always available to edit. Once Damping Time has been enabled, the
Filter Time Constant is really practice into use.
Damping Time
To change the Damping Time:
1. Click Damping Time Enable (Figure 217).
Figure 217 Click Damping Time Enable
2. Enter a new Damping Time and click Apply.
If you enter a Damping Time variable less 0.10 sec and greater than 60.00 sec, an error
message appears (Figure 218).
Figure 218 Damping Time Error Message
Applying Filters and Tuning Changes
When you make any changes in the Filters and Tuning window, click Apply to save.
Calibration Filter
It is ratio filter and always available to edit when OOS mode.