Technical Specifications

229

Configure

What You Can Do on the Configure Tab

In the Setup mode, from the Configure tab (see Figure 31), you can set the information that tells

the SVi1000 how the valve/actuator is configured by adjusting the following parameters:



“Tag Information” on page 230  “Position Fault Limits” on page 231

 “Characterization” on page 232  “Air Action” on page 235

 “Bumpless Transfer” on page 236  “Position Limits” on page 236

 “DO Output Switches” on page 237  “Configure Context Menu” on page 239

Before making any configuration changes on the Configuration tab

SVi1000 must be in Setup mode. If you need to change modes refer to

“Change Mode” on page 190.