Technical Specifications

ValVue Digital Communications Software Ver. 2.80
208
GE Oil & Gas
The allowed SVi1000 Parameters are listed in Table 1. Use the report file (report.rtf) shipped
with the application for examples.
rtf files are preferred as you can apply special formatting to the file that
can contain fonts, sizes, tabs, etc. and bitmaps. Some .rtf formatting is
accepted in Word which is not available in WordPad.
Table 1 Report Setup Parameters
Report Parameter Information Provided in Report
$$Tag Tag Name
$$Descriptor Descriptor
$$Date Date
$$Message Message
$$AssemblyNumber Final Assembly Number
$$MfgID Manufacturer’s ID (101 for Masoneilan)
$$DeviceType Device Type (200 for the SVi1000)
$$DeviceID Hart DeviceID
$$HWRev Hardware Revision
$$SWRev Software Revision
$$CmdRev Firmware Command Revision
$$PollingAddress PollingAddress
$$Position Position
$$Signal Input Signal
$$Pressure Actuator Pressure
$$IPOutput Signal to the I/P in Counts (0 to 65000)
$$Temperature Circuit Board Temperature
$$LowTemperature Historical Low Temperature
$$HighTemperature Historical High Temperature
$$Output Output from the process controller
$$Mode SVi1000 Mode
$$SignalPercent Input Signal as Percent
$$AirAction Air to Open/Air to Close