Technical Specifications

ValVue Digital Communications Software Ver. 2.80
202
GE Oil & Gas
Changing the Setpoint
Change to Manual mode prior to changing the position indicator; click on Change Mode and
select Manual. There are three ways to change the position indicator:
 Entering the setpoint value in the Setpoint dialog.
 Dragging the position indicator.
 Left clicking on either side of the position indicator modifies the setpoint by 5%.
To enter a value for the position indicator setpoint:
1. Right click inside the position indicator area.
The Setpoint dialog appears.
Figure 10 Setpoint
2. Enter the setpoint percentage and click OK.
3. Status on the Monitor Tab
The SVi1000 tracks operation and provides several health indicators. When there is a fault
code available in the SVi1000, this box contains (Figure 11) Additional Status Available. The LED
is green for OK or red when a flag is set. The fault codes can be retrieved by:
1. Select Read Status from the
Send Command drop down list.
2. Click Send Cmd.
The status block also contains other status codes returned by HART. These include
Configuration Changed, Cold Start, Device malfunction, and Variable out of limits.
Figure 11 Monitor Tab: Additional Status Available