Installation Guide

AC line
GEPS24-180
Wire AC line to LED driver(s) in accordance with the
applicable local, state, and country electrical codes.
Connect black to black or brown, white to white or
blue, and green to green using 18 AWG (0.82mm
2
)
wire connectors.
Add up total footage of the system to determine the
appropriate number of 24VDC Class 2 Tetra
®
LED drivers
to use based on the Power Supply Loading chart on
last page.
3
1
Connect the red stripe wire (+) of the LED system to the
red wire (+) of the power supply. Connect the white wire
(-) of the LED system to the black or blue wire (-) of the
power supply.
Connect Line Fit Lights using twist-on wire connectors or in-line (IDC) connectors. Join white wires together and red striped
wires together. Cap all exposed wires with appropriate end caps or apply electric grade (non-corrosive) silicone for additional
weather protection.
NOTE: Make sure not to exceed LED driver power limits (see Step 1). Drawing above is for reference only; your lighting layout
may differ.
NOTE: All drivers except GEPS24-180U must be installed in a raceway or be provided with a GEPSJB60 LED driver extended enclosure.
If installing multiple LED drivers, keep them at least
2” (50.8mm) apart end to end and 4” (101.6mm) apart
along the sides.
4
5
2
AC line
Black to black or brown (-)
Green to green
White to white or blue (+)
Power supply
Electrical Connections
4”
2”
LED driver LED driver
LED driver LED driver
To Line Fit Light
Red (+)
Red stripe (+)
White (-)
Black or blue (-)
23.0W
23.0W
23.0W
23.0W
23.0W
23.1W
Total: 161W
11.5W 11.5W
Add up total length of system