Specification

Specification Revised 10/23
JVM6175DK
GE Appliances 1.7 cu. ft. Over-the-Range Sensor Microwave Oven
Filler Panel Kit JX36BWW/
BBB/BSS/BES/BTS
When replacing a 36" range hood,
this kit fills in the additional width to
provide a custom built-in
appearance. For installation
between cabinets only; not
for end-of-cabinet installation.
Each kit contains two 3"-wide
filler panels.
Filter Kit
WB02X35687
(included)
Recirculating
Charcoal Filter Kit
To be used when
the microwave oven
cannot be vented
to the outside.
DUCT EQUIVALENT FEET
A.
Rectangular-to-round
Transition Adaptor 5 ft.
B. Wall Cap 40 ft.
C. 90° Elbow 10 ft.
D. 45° Elbow 5 ft.
E. 90° Elbow 25 ft.
F. 45° Elbow 5 ft.
G. Roof Cap 24 ft.
OPTIONAL ACCESSORIES
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
For answers to your Monogram, Café™, GE Profile™ or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
HOOD EXHAUST DUCT: Outside ventilation requires a HOOD
EXHAUST DUCT. Read the following carefully.
EXHAUST CONNECTION: The hood exhaust has been designed to
mate with a standard 3-1/4" x 10" rectangular duct. If a round duct is
required, a rectangular-to-round transition adaptor must be used. Do
not use less than a 6" diameter duct.
REAR EXHAUST: If a rear or horizontal exhaust is to be used, care
should be taken to align exhaust with space between studs, or wall
should be prepared at the time it is constructed by leaving enough
space between the wall studs to accommodate exhaust.
MAXIMUM DUCT LENGTH: For satisfactory air movement, the total
duct length of 3-1/4" x 10" rectangular or 6" diameter round duct
should not exceed 140 equivalent feet
ELBOWS, TRANSITIONS, WALL AND ROOF CAPS, etc., present
additional resistance to airflow and are equivalent to a section of
straight duct which is longer than their actual physical size. When
calculating the total duct length, add the equivalent length of all
transitions and adaptors plus the lengths of all straight duct sections.
The chart below shows the approximate feet of equivalent length of
some typical ducts