Installation Guide

ASSEMBLE AND INSTALL
ADAPTOR
14
Rotate front of oven up
against cabinet
bottom.
1
MOUNT THE OVEN
A6.
A5.
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting the
oven, thread power cord
through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1–3.
Do not pinch cord or lift oven
by pulling cord.
Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting
plate.
Damper
Back of
Oven
Installation Instructions
Place the oven in its upright position, with the top of
the unit facing up.
NOTE: Make sure the blower fan blades are visible
and are pointing up.
Insert the tabs on each side of the damper into the
holes at the inside rear of the adaptor.
Exhaust
Adaptor
1
2
Blower Plate
NOTE: On some models, the exhaust adaptor and damper
assembly may already be assembled to the oven.
Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the
blower unit wiring. Make sure the wires are not
pinched.
6
6
Replace blower plate and replace screws for blower
plate and blower motor removed in Step 1.
Blower Plate
Back of
Oven
Blower Plate Screws
Blower Motor Screw
ADAPTING BLOWER FOR OUTSIDE
VENTILATION
(continued)
A4.
Attach the exhaust adaptor to the blower plate with
the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
oven is installed.
3