Installation Guide

ADAPTING BLOWER FOR

OUTSIDE VENTILATION

USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws, a hole

large enough for the power cord to fit through, and a

cutout large enough for the exhaust adaptor.

CHECK BLOWER MOTOR

ORIENTATION

The blower fan blade opening should be facing the top

of the microwave. If the fan opening is already facing

the top of the microwave, skip to Step A5. Otherwise,

continue to Step A4 to adjust the motor orientation.

A2.

A3.

•

Read the instructions on the TOP CABINET

TEMPLATE.

• Tape it underneath the top cabinet.

• Drill the holes, following the instructions on the TOP

CABINET TEMPLATE.

CAUTION: Wear safety goggles

when drilling holes in the cabinet bottom.

Installation Instructions

A4.

Carefully pull out the blower unit. The wires

will extend far enough to allow you to adjust the

blower unit.

Roll the blower unit 90° so that fan blade openings

are facing toward the top of the microwave.

Roll

Slide the blower plate from under its retaining

flange and lift it off.

Remove and save screws that hold blower plate and

blower unit to the oven.

BEFORE: Fan Blade

Openings Facing Front

Blower Plate

Retaining

Flange

Blower Plate

Back of

Oven

Blower Plate Screws

Blower Motor Screw

AFTER: Fan Blade

Openings Facing