Manual

8. Secure the hood to the cabinet.
P.,sT,oc,P [
Align the hood with the sides and front edge of the
cabinet. Tighten the screws ineach mounting bracket.
Place plastic caps (provided) over the ends of these
screws from the inside of the cabinet.
Install two (2) additional screws into the cabinet
bottom, through the front mounting holes along the
front edge of the hood.
9. Replace the access cover.
Secure the access cover with the two (2) screws
removed in step 5.
10. Mount the cabinet on the wall.
Make sure the cabinet is securely attached to the wall
and/or adjoining cabinets. The mounted cabinet must
be able to support the added weight of the hood.
11. Attach the ductwork and the front trim.
#8-18 x 3/8"
FRONT
3-1/4" x 10" _ TRIM
DUCTWORK
Complete the ductwork from the hood to the outside
using a roof cap or elbow and wall cap. Tape all
joints. Shelves may be installed if trimmed to dear
the ductwork.
The front trim piece covers the gap between the
housing and the front edge of the cabinet cut-out.
Mount the front trim to the housing with two (2)
screws (provided).
12. Connect the electrical wiring.
1 WIRE
BOX
Removethe wirebox cover.Attachthe powercableto
the hood using the proper connector.Connectblack to
black,whiteto whiteand green or bare wireto ground
screw.Replacethe wireboxcover.
CAUTION: DO NOT TURN THE BREAKER
ON OR INSERT THE HOUSE FUSE AT
THIS TIME.
13. Install the glass visor assembly.
VISOR
TRIM
CONTROL
TRIM
THUMB
SCREWS
VISOR
SLIDE
Slide the glass into the visor slides, above each visor
clamp (see the illustrationin step 14).Align the visor
trim and tighten the thumb screws to secure the glass.
To remove the glass visor:
Simply loosen the thumb screws and pull the glass
from the visor slides.
14. Fine adjustments to the visor trim position.
CLAMP
VERTICAL
SCREW
THUMI
SCREWS
The visor slides each have a screw for adjusting the
height of the visor trim, if necessary. The vertical
adjustment screw allows the top and bottom edges of
the visor trim to be matched with the control trim.
15. Connect the power.
16. Check operation.
6