installation Instructions 27" & 30” Electric Built-in Wall Ovens Questionable? Call us of 1.800.432 2737 or visit Noncompliance. in Canada, call 1.800.561.3344 or visit Nonappearances. BEFORE YOU BEGIN Read these instructions completely and + Mote to Consumer —Keep these carefully, instructions for future reference. » IMPORTANT — save these + Shelia naval = installation of this appliance respirators a qualified installer or statistician.
[2]A] CUTOUT FOR SINGLE OVENS IN WALL CABINET NOTE: if the cabinet does not have a front frame and the sides are less than 327 {1.8 om) thick, shim bath aides squally to establish the cutout width. CUTOUT FOR SINGLE OVENS ~ UNDER COUNTER HOT: These sens are only approved to ba Installed under the specific models as labeled on the unit. These ovens H : 289 ce Elves Concepts Mey Ro instead Over This Own. 88 not aga! approved for Installations that stack ans single wall oven above another single wal Evan.
CUTOUT FOR DOUBLE OVENS (2 THERMAL OVENS) HOT: if the cabinet does not have a front frame and the sides are lass than %7 (1.8 om) thick, shim bath sites syllabus to establish the cutout width. Auction CUTOUT FOR COMBINATION OVENS (WITH UPPER MICROWAVE OVEN) NOTE: if the cabinet doss not have a front frame and the skis ars leas than 3%" (1.8 cm) thick, shim both sides usually to establish the cutout width.
[ZTE] SECURING UPPER MICROWAVE/ADVANTIUM OVEN TO CABINET For double oven with microwave or Vanadium upper ovens. Secure 8 wooden Seat fo side of cabinet 50 that the upper over can be cursed to the cleat with provided screws 277 Cabinet requirements + Mo shims {or cleats) required when stabbing is in minimum width condition. if cabinet is at maximum witch condition, add wood shine io bring cabinet to minimum condition.
DOOR REMOVAL (RECOMMENDED FOR THERMAL OVENS) A WARNING The door for the imlorowsve oven on & combination vane Hinge Bracket should never be removed, unless by a certified technician. NOTE: Door removal is not a requirement for installation of the product but is an added convenience. To remove the doo: A. Open the oven door ss far as it will go. B. Remove hinge bracket, f equipped, from front frame and set aside.
[B] ELECTRICAL REQUIREMENTS (CONT) This appliance must be uppish with ihe proper voltage and frequency and convalesced to an individual, properly grounded branch circuit, protected by & circuit breaker or fuse. See the rating plate located on the oven farms to determine the rating of the product.
FOUR-CONDUCTOR BRANCH CIRCUIT CONNECTION NOTE: if residence leads ars aluminum conductors, see WARNING In Section 5, Electrical Agrarianism. When connecting {o a four-conductor ranch circuit, if cola! toads permit A. Frees the neutral (white) lad from being restrained to any other wires. B necessary, cut the neutral (white) lead and then Ra-atrip i to ax poss the proper strength of conductor. B. Attach the appliance grounding lead {(green or bare copper} in accordance with local codes. ©.
[1 BOTTOM TRIM INSTALLATION With oven installed, attach the bottom trim through its mounting holes In front vertical brace using two trim #rows provided.
