Manual

Read these instructions completely and carefully.
Step 2--Install WarmingDrawer
[] Slide the left corner into opening and push
power cord into the hole leading to the
outlet location. Thread the cord through
as drawer is being pushed back into the
opening.
If the outlet is installed inside the
opening, plug the cord into the outlet.
In this location, the excess power cord
should be coiled and taped to the i_ight
side of the unit. Make sure the cord does
not get t_wpped by the chmve_:
/VOTE'.Insure that the power cord does not
contact the hot sm-li_ces on the bottom of
ovens, cooktops, or any other appliance.
[] Push the drmver back until the front flange
is flush to the cabinet fl'ont.
[] Drill pilot holes through the holes in the
oxerlapping tl"aIIle, one on each coYneI:
[] D_ixe wood scrm_s proxided into each
coYnei;
[] Open the drawer flfllv.
15