Manual
Installation of the warming drawer.
Read these instructionscompletely and carefully.
Step2--Install WarmingDrawer
[]
Slide the left corner into opening and push
power cord into the hole leading to Ihe
outlet location. Thread the cord Ihrough as
drawer is being pushed back into the
opening.
If the outlet is installed inside the opening,
plug the cord into Ihe outlet. Coil lx)wer
cord and inslall it in 1he clip on the right side
of the unit. Make sure Ihe cord does not get
trapped by the &_awer.
NOTE: Insure that the tx/wer cord does not
contact the hot surfaces (In the bottom (If
ovens, cooktops, or any other appliance.
[] Push the drawer back until the fi'ont flange
is flush to the cabinet front.
[] Drill pilot holes through Ihe holes in the
overlapping frame, one on each corner.
[] Drive wood screws provided into each
cornel',
[] ()pen the dFawer fully.
16