Manual

Read these instructionscompletely and carefully.
ProvideCabinetSupport
23W'
2" x 4" orequivalentrunners
i
i
i
i
i
i
i
i
i
i
22"_
27"! 2
23½"
2"x4"orequivalentrunners
i
30'_
IMPORTANt When installed below a single or
&)uble oven, check m be sure that any oven
supports above the cutout do not obstruct the
23_k" reqMred depth of the warming drawer
culout.
_ A 2" minimum clearance between oven
and warming drawer culouks are required,
Additional dear _ance may be required if
2 x 4 blocks are used Io support nmners or
solid floor of the oven above.
_ The waruling drawer may be suppon:ed by
either a solid bottom, 2 x 4 or 2 x 2 runners.
_The support must be level and ri_dly
mounted, flush wilh lhe bottom edge
of the cutouL
There is no way to level the drawer once it
has been &staffed. Be sure supports are level
_ The entire weight of the drawer is suppon:ed
by the runners or _)lid floor and must be
capable of supporting 150 lbs.
Step l--Install Anti-TipBrace
WARNING: ANT1-TIPPRECAUTIONS:
The anti-tip brace must be &staffed to prevent
the drawer from tipping forward when opened
and loaded.
Failure to doso could result in personal injuq.
_.. Install2x4or2x2anti-tipbrace
against rear cabinetwail9"
. fromfloortobottomofbrace
I T
/ i /
-" 2x4or2x2runners
orsolidbottom
15