User Manual
20 49-80815
Metal Marks and Scratches
1.  Be careful not to slide pots and pans across your 
cooktop. It will leave metal markings on the cooktop 
surface.
 These marks are removable using the CERAMA 
BRYTE
®
 Ceramic Cooktop Cleaner with the CERAMA 
BRYTE
®
 Cleaning Pad for Ceramic Cooktops.
2.   If pots with a thin overlay of aluminum or copper 
are allowed to boil dry, the overlay may leave black 
discoloration on the cooktop.
  This should be removed immediately before heating 
again or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness 
that would scratch the cooktop.
Damage from Sugary Spills and Melted Plastic
Special care should be taken when removing hot substances to avoid permanent damage of the glass surface. 
Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your 
cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when 
removing hot substances.
Be sure to use a new, sharp razor scraper.
'RQRWXVHDGXOORUQLFNHGEODGH
1.  Turn off all surface units. Remove hot pans.
2.  Wearing an oven mitt:
  D 8VHDVLQJOHHGJHUD]RUEODGHVFUDSHUWRPRYH
the spill to a cool area on the cooktop.
 b.  Remove the spill with paper towels.
3.  Any remaining spillover should be left until the surface 
of the cooktop has cooled.
'RQ¶WXVHWKHVXUIDFHXQLWVDJDLQXQWLODOORIWKH
residue has been completely removed.
NOTE: If pitting or indentation in the glass surface has 
already occurred, the cooktop glass will have to be 
replaced. In this case, service will be necessary.
Cooktop Seal
To clean the cooktop seal around the edges of the glass, 
lay a wet cloth on it for a few minutes, then wipe clean 
with nonabrasive cleaners.
Cleaning the Glass Cooktop (Cont.)
CARE AND CLEANING: Cleaning the Glass Cooktop










