Installation guide

ManualsBrandsGE ManualsCooktopOfficial GE electric cooktop

I stollotio

I structio s

30" ectricCooktop

CP350, JP336, JP340, JP346, JP356, PP912, PP932,

PP942, PP944, PP945, PP950

I-_ If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completely and carefully.

. IMPORTANT - Soretheseinstructions

for local inspector's use.

, IMPORTANT - Observeollgoverning

codes and ordinances.

, Note to Installer- Be sure to leave these

instructions with the Consumer.

, Note to Consumer - Keep these instructions for

future reference.

, Product failure due to improper installation is not

covered under the Warranty.

A WARNING - This appliance must be

properly grounded.

. ATTENTION INSTALLER - ALL

COOKTOPS MUST BE HARD WIRED {DIRECT

WIRED) INTO AN APPROVED JUNCTION BOX. A

"PLUG AND RECEPTACLE" IS NOT PERMITTED

ON THESE PRODUCTS.

, Proper installation is the responsibility of the

installer and product failure due to improper

installation is NOT covered under warranty.

MATERIALS YOU WILL NEED

Junction Box Wire Nuts

TOOLS YOU WILL NEED

Pencil

Phillips Head

Screwdriver

Ruler or Straightedge

Saber Saw

1/8" Drill Bit & Electric or

Hand Drill

Safety Glasses

PARTS INCLUDED

4 Screws

(WB1X!!37)

Foam Tape

2 Hold Down

Brackets

31-10637-7 (07-!] GE) 1

Summary of content (16 pages)

PAGE 1
I stollotio 30" ectric Cooktop I structio s I-_ If you have questions, BEFORE YOU CP350, JP336, JP340, JP346, PP942, PP944, PP945, PP950 call 800.GE.CARES or visit our website completely . IMPORTANT at: GEAppliances.com and carefully. use. , IMPORTANT - Observe ollgoverning Junction Box codes and ordinances. , Note to InstallerBe sure to leave these instructions with the Consumer. , Note to Consumer future reference.
PAGE 2
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS w FOR YOUR SAFETY ELECTRICAL REQUIREMENTS , For Personal Safety, remove house fuse or open circuit breaker before beginning installation. Failure to do so could result in serious injury or death. This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or a time delay fuse as noted on name plate.
PAGE 3
Installation PRE-INSTALLATION Instructions CHECKLIST Fa Remove WARN ING - Theelectrical powerto Installation Instructions from literature pack and read them carefully before you begin. the cooktop supply line must be shut off while connections are being made. Failure to do so could result in serious injury or death. r_ When preparing cooktop opening, make sure the inside of the cabinet and the cooktop do not interfere with each other. (See section on preparing the opening.
PAGE 4
Installation PREPARING THE OPENING Instructions (Cont) CUTOUT DIMENSIONS OF THE COUNTERTOP E_ For Americans with Disabilities Act (ADA) Forward Approach Installation Only: To insure accuracy, it is best to make a template when cutting the opening in the counter. th of cut i-3/4" Min. Between _ cutout and the wall 2-1/2" Min.
PAGE 5
Installation Instructions INSTALLING THE COOKTOP INSTALLING THE JUNCTION BOX Install an approved junction box where it will be easily reached through the front of the cabinet where the cooktop will be located. The cooktop conduit is 3 feet long. F_ ATTACH FOAM TAPE Apply the foam tape around the outer edge of the glass. Do not overlap the foam tape. Bottom of Cooktop -- -.. Foam_Tape ................ ".......... o z t 16" Min.
PAGE 6
Installation Instructions INSTALLING THE COOKTOP (CONT.) INSERT COOKTOP INTO CUTOUT Insert the cooktop centered into the cutout opening. Moke sure the front edge of the countertop is porollel to the cooktop. Moke finol check thot oil required cleoronces ore met. [_ ATTACH HOLD DOWN TO CABINET BRACKETS Open the cobinet door ond screw the hold down brockets to the cobinet sides with the screws provided.
PAGE 7
Installation INSTALLATION--ELECTRICAL Instructions CONNECTIONS B] When making the wire connections, use the entire length of conduit provided. The conduit must not be shortened. B] With the cooktop in place, open the front of the cabinet door. El Insert the wires from the conduit through openinq of the junction box. r_ once the connections are made, secure wires together using wire nuts.
PAGE 8
Installation Instructions CHECKLISTS [i] [] D PRE-TEST CHECKLIST Remove all protective stickers. []_] OPERATION film, if present, and any Remove all items from the top of the cooktop surface. Check to be sure that all wiring is secure and not pinched or in contact with moving parts. [] Check B1 Check level of appliance. that the cooktop is properly grounded. CHECKLIST Turn on the power to the cooktop.(Refer to your Owner's Manual.) Verify that all surface burners operate properly.
PAGE 9
Instruccio Estufa el ctrica deinstalaci6n CP350, JP336, JP340, JP346, PP942, PP944, PP945, PP950 "Si tiene alguna pregunta, llame al 800.GE.CARES nuestro PP912, PP932, sitio Web en: GEAppliances.com" NECESITARA LOS SlGUIENTES MATERIALES ANTES DE COMENZAR Lea estas instrucciones y con cuidado. o visite JP356, e 30" por completo .IMPORTANTE - Conserve estos instrucciones poro eluso delinspectorlocal. .IMPORTANTE -cumplocontodos los Caja de empalmes c6digos y reglosoplicobles.
PAGE 10
Instrucciones de instalaci6n INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD REQUISlTOS ELECTRICOS . Para su seguridad personal, retire los fusibles de su hogar o bien abra el cortacircuitos antes de comenzar con la instalaci6n. El no hacerlo puede resultar en lesiones serias o incluso la muerte. Este aparato debe contar con el voltaje y frecuencia adecuados, y deber6 conectarse a un circuito derivado individual debidamente .
PAGE 11
Instrucciones de instalaci6n J J LISTA DE VERIFICACION PREVIA A LA INSTALACION A ADVERTENCIA - Lacorriente el_ctrica a la tuberia de abastecimiento cortarse durante la realizaci6n no hacerlo muerte, puede resultar El de la estufa debe de conexiones. El en una lesi6n seria o la [] Cuando se prepare para la abertura de la estufa, asegOrese que el interior del gabinete y la estufa no interfieran uno con el otro. (Consulte la secci6n de preparaci6n de la abertura).
PAGE 12
Instrucciones de instalaci6n J PREPARACION DE LA ABERTURA [_] DIMENSIONES DEL AREA CORTADA EN EL MOSTRADOR (Cont) []_] Instalaci6n Por Delante 0nicamente con la Ley de Estadounidenses con Incapacidades (ADA) de Acuerdo Para garantizar la precisi6n, es mejor crear una plantilla al momento de cortar la abertura en el mostrador. 19-5/8" ancho del corte ! 1-3/4" Mfn.
PAGE 13
Instrucciones de instalaci6n J INSTALACION DE LA ESTUFA rT1 INSTALACI6N DE LA CAJA DE EMPALMES Instale una caja de empalmes aprobada en un lugar de f6cil acceso a trav#s del frente del gabinete en donde pueda colocarse la estufa. El conducto de la estufa tiene 4 pies de Iongitud. [_] APLIQUE LA CINTA DE ESPUMA Aplique la cinta de espuma alrededor del borcte externo del vidrio. No aplique un exceso de cinta de espuma. Parte inferior de la estufa j _ - -. Cinta de espuma ' j/ jj . o .
PAGE 14
Instrucciones de instalaci6n J INSTALACION [_] DE LA ESTUFA (CONT.} INSERTE LA ESTUFA EN EL AREA CORTADA Inserte la estufa centrada en el 6rea cortada. Aseg@ese de que el borde frontal del mostrador est6 paralelo con respecto a la estufa. Aseg0rese de verificar al final que todos los espacios especificados hayan sido respetados. IlL] SUJETE LAS ABRAZADERAS DE MONTAJE AL GABINETE Abra la puerta del gabinete y atornille las abrazaderas de montaje a los lados del gabinete con los tornillos incluidos.
PAGE 15
Instrucciones de instalaci6n J J INSTALACION--CON EXION ES ELECTRICAS r_ cuando realice las conexiones de cables, utilice toda la extensi6n del conducto incluido. El conducto no debe reducirse. r_ una vez que se hayan realizado las conexiones, fije los cables con las tuercas para cables. R#o Con la estufa colocada en su lugar, abra el frente de la puerta del gabinete. Inserte los cables del conducto a trav6s de la abertura de la caja de empalmes.
PAGE 16
Instrucciones de instalaci6n J LISTAS DE VERIFICACION r_ LISTA DE VERIFICACI6N Retire toda la pelicula protectora, y las calcomanias. PREVIA [_] si la hay, [] Verifique que todos los cables est6n fijos y que no est6n torciclos o en contacto con partes m6viles. Verifique que la estufa est6 descargada a tierra correctamente. Retire todos los objetos que se encuentren sobre la superficie de la estufa. Encienda (Consulte que todas funcionen EC_ Verifique el nivel del aparato.