Manual

Replaceablecharcoalfilter
NOTE: DONOTrinse, or put charcoal filters in
an automatic dishwasher
Charcoal Filter-Recirculating Installations Only
The charcoal filter cannot be
cleaned. It must be replaced. Order
filter no. WBO2XI0700. Replacement
filters can be ordered from your GE
supplier.
If the hood is not vented to
the outside, the air will be
recirculated through a disposable
charcoal filter that helps reinove
Sil/oke and odors.
Toremove:
Pull down on the center of the
fl'ont edge of the filte_; The filter
will then slip out of the retaining
tabs on the back.
Toreplace:
Slip the back edge of the filter
into tile retaining tabs and push
the fl'ont edge up until it snaps
into place.
The charcoal filter should be
replaced after 6 to 12 months
(depending on hood usaoe,_ ).
Painted Surfaces
Do not use steel-wool pads or other
abrasive cleaners. They will scratch
the surface.
Clean grease-laden surlhces of the
hood fl'equently: To clean the hood
surtace, use a hot, damp cloth with a
mild detergent suitable tot painted
surtaces. About one tablespoon of
ammonia mav be added to the water.
Use a clean, hot, damp cloth to
relnove soap. Dry with a dry;
clean cloth.
NOTE:_hen cleaning, take care not
to come in contact with filters and
other non-enameled surfaces.
CAUTION:When cleaning the hood
surfaces, be certain that you do not
touch the light bulb with moist hands or
cloth. A warm or hot light bulb may break
if touched with a moist surface. Always
let the light bulb cool completely before
cleaning around it.
Lightcover
Hood Light
CAUTION:I,et tile light bulb cool
completely belm'e removing.
A warm or hot bulb may break
if touched with a moist cloth
or hand.
Remove the bulb and replace with
an ordinary scrm_q)ase light bulb,
not more than 60 watts.
To remove the light cover
(on some models):
• Press the sides with two finge_
until the side prongs are
released.
• i,ift tile light cover and slide it
toward _o/i in one illotion.
Toreplace the light cover:
• Insert the prong located at the
end of the cover into the top
opening.
• Gently push the cover up and
press the sides to fit the side
prongs into the side openings.
• Release and the cover will lock
in position.
5