Manual

Installation Instructions
[] MARK HOLES
Select the xent option that _our installation will
require and proceed to that section:
A. Outside top exhaust
(Vertical duct-31/4" x 10" Rectangular)
• Use the diagran_ or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Hoodmountingscrews(4)
133/4'' (30" hood)
16W' (36" hood)
133/4'' (30"hood)
163/4'' (36"hood)
Wood shims (recessed- { Electrical access hole
Center (in cabinet bottom)
bottomcabinetsonly) line
B.Outside top exhaust (Vertical duct-T' Round)
• Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Hoodmountingscrews(4)
13¾"(30" hood)
(36" hood)
front
13¾"(30" hood)
Electrical access
Wood shims (recessed- Center hole (incabinetbottom)
bottomcabinetsonly) line
C. Outside rear exhaust
(Horizontal duct-31/4" x 10" Rectangular)
• Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots,
Woodshims(recessed-bottomcabinetsonly)
B_abiiet frontal//, lY4,,
133/4"(30" hood)
163A"(36" hood) 16sA" (36" hood)
Electricalaccesshole
Hoodmountingscrews(4) line (inwall)
D. Recirculating (non-vented ductless-
JN327 and RN328, and optional on
JV347 and JV367 models only)
• Use the hood as a template and mark the locations
on the cabinet for the electrical wiring and keyhole
scI'ew slots.
• Since the hood is to be recirculated (not to be xented
outside), do not cut out any xent oi)enings, in the wall
or cabinet bottom.
13