Manual

Installation Instructions

[] REMOVE DUCT KNOCKOUT

If recirculathag, i_oi>vented ductless (1N327 and RN328,

and optional for.fV347 and,IV367 models only), skip to

Step 10 D mid proceed.

Using a fiat blade screwdi'i\'er, relnove the appropriate

duct knockout fl'oln the top or back of the hood.

3'/4"x 10" Rectangular

vertical discharge.

Remove top rectangular

duct knockout only.

7" Roundvertical

discharge.Removecircular

ductknockoutonly.

3'/4" x 10" Rectangular

horizontal discharge. Remove

rear rectangular duct knockout only.

[]

FOR 3¼" X 10" RECTANGULAR

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Attach exhaust adaptor/damper ()vet" the appropriate

knockout opening (fin" vertical or hot_izontal,

depending on installation) with two exhaust adaptor

screws. Make sure dalnper pivot is nearest to top/back

edge of hood. ]_elnove tape fl'oln dalnper flap.

Upto 1" side-to-

sideadjustment

Exhaustadaptor/damper

(verticaldischargeposition)

Pivot

(dependingon Top/backedge

installation) Exhaustadaptor/damper

(horizontaldischargeposition)

NOTE: The exhaust adaptor/danq)er can be installed

up to 1 inch oi1 either side of the hood center to

accotntnodate oflLcenter ductwork, 111 extretne off L

center installations, one end of the duct connector may

need to be trilnlned to clear the electrical cable clalnp.

[] FOR 7" ROUND VERTICAL

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Bend up the duct alignment eat_ in preparati(m for

later attachment of the t duct.