Manual

Installation Instructions
[] REMOVE EXHAUST ADAPTOR
If exhausthag/venting using the 3¼" x 1O" rectangular
duct--optional for JV338, JV347 mad JV367 models
tufty:
]_.elnove the exhaust adaptor fl'om the inside of the
hood. Set it aside along with its mounting screws.
31/4"x 10"
rectangular
exhaust
adaptor
and screws
[] REMOVE FILTER
])-.elllOVe the shipping tape holding the metal grease
filter in place. Pull down on the center of the fl'ont
edge of the filter. The filter will then slip out of the
retaining tabs on the back.
CD
Metal grease filter
[] REVERSE THE BAFFLE FOR
DUCTED INSTALLATIONS ONLY
(JV347 and JV367 models)
If the hood is to be recirculated, skip to the next step.
Remove the baffle fl'om the top of the hood. Re-install
the baffle so the short side marked "VENTED" is
visible. The long side of the baffle should be inside
the hood.
"VENTED"is visible
[51REIVIOVE WIRING COVER
Remo_e the wiring cover ti'om inside the hood,
Set the cover and its mounting screw aside.
Wiring
cover\
[] REMOVE WIRING KNOCKOUT
Remo_e either the top or the back wiring knockout as
needed and install an approxed s_caJn relief clamp,
Backknockout
Topknockout
Strainrelief
clamp
Strain relief
clamp
11