Manual

CD
Replaceablecharcoalfilter
NOTE; DONOTrinse, or put charcoal filters in
an automatic dishwasher
Charcoal Filter--Recirculating Installations Only
The charcoal filter cannot be cleaned.
It must be replaced. Order filter no.
WBO2XI0700. Replacement filters
can be ordered fromyour GEsupplier.
If the hood is not vented to the
outside, the air will be recirctdated
through a disposable charcoal filter
that helps remove smoke and odols.
The charcoal filter should be
replaced alter 6 to 12 moI_ths
(del)ending on hood usage).
Toremove:
Pull down on the center ot the front
edge of the filtei: The filter will then
slip out of the retaining tabs on the
back.
Toreplace:
Slip the back edge ot the filter into
the retaining tabs and push the
fl'ont edge up until it snaps into
place.
Stainless Steel Surfaces (onsome models)
Do not usea steel-wool pad; it will
scratch the surface.
To clean the stainless steel
Stli'J[ilce, use W}llIll sudsy water or
a stainless steel cleaner or polish.
Always wipe the smti_ce in the
direction of the grain. Follow the
cleaner instructions t0r cleaning
the stainless steel smthce.
To inquire about i)urchasing
stainless steel appliance cleaner or
polish, or to find the location of a
dealer nearest you, please call our
toll-fl'ee nunlber:
NationalPartsCenter 800.626.2002
go.corn
Painted Surfaces (onsomemodels)
Do not use steel-wool pads or other
abrasive cleaners. They will scratch
the surface.
Clean grease-laden smti_ces of the
hood fl'equently. To clean the hood
surfilce, use a hot, damp cloth with a
mild deteigent suitable for painmd
surtilces. About ()lie tablespoon ot
amlnolfia inav be added to the
wateI: Use a clean, hot, dam I)
cloth to relnove soap. Dia' with
a (hN clean cloth.
NOTE:When cleaning, take care not
to come in contact with filteI_ and
other non-enai/leled Stli];ices,
CAUTION: When cleaning the
hood surfaces, be certain that you
do not touch the light bulb with moist
hands or cloth. A warm or hot light
bulb may break ff touched with a moist
surface. Always let the light bulb cool
completely before cleaning around it.
Lightcover
CAUTION: Use only a type A 15h)ht bulb,
60 Watt maximum.
Hood Light
CAUTION: i,et the light bulb cool
colnpletely beli)re renlovillg. A
WalIn or hot bulb nlav break if
touched with a moist cloth or hand.
]lemove the bulb and replace it
with a t}pe A15 light bulb with an
ordinal y scI'e_q)ase, not more than
60 watts.
Toremove the light cover
(on some models):
• Press the sides with two fingeI_
until the side I)rongs are released.
• Lift the light cover and slide it
toward veil iI1 one illotion.
Toreplace the light cover:
• Insert the i)rong located at the
end of the cover into the top
opening.
• Gently push the cover up and
press the sides to fit the side
prongs into the side openings.
• Release and the cover will lock
in position.
5