Manual

Installation Instructions

[] FOR 31/4"X 10" RECTANGULAR

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Attach exhaust adaptor/damper over the appropriate

knockout opening (fin" vertical or horizontnl,

depending on installation) with two exhaust adaptor

scre_:s. Make sure dalnper pivot is nearest to top/back

edge ot hood. ]/elnove tape from dalnper flap.

Upto 1" side-to-

sideadjustment

Exhaustadaptor/damper

(verticaldischargeposition)

Pivot Top/backedge

(dependingon

installation) Exhaustadaptor/damper

(horizontaldischargeposition)

NOTE: The exhaust adaptor/danq)er can be installed

up to 1 inch oi1 either side of the hood center to

accommodate ottLcenter (hlctwork. 111 extre111e ott L

center installations, one end of the duct connector 1nay

need to be tfinuned to clear the electrical cable clalnp.

[] FOR RECESSED-BOTTOM

CABINETS ONLY

Wood shims

(minimumthickness 3/8") "-'---

• If the cabinets have fl'ont, side oi" back triln, make

2 wood shilns a nlininlunl of 3/8" thick and cut to

fit the width of the inner recessed cabinet bottom.

Attach theln to the cabinet bottom recess on both

sides, See Step 11 for 1harking locations,

[] FOR 7" ROUND VERTICAL

DUCTED DISCHARGE

INSTALLATIONS ONLY:

Bend up the duct alignment ears in preparation fin.

later attnchlnent of the 7" duct.