Manual

Installation Instructions
[] REMOVE EXHAUST ADAPTOR
If exhausting/venthlg using the 3¼" x 10" rectangular
duct---optional for JV338, Jv347, Jv348 mad JV367
models tufty:
I_.emove the exhaust adaptor fl'oln the inside of the
hood. Set it aside along with its mouI]tiI]g screws.
31/4"x 10"
rectangular
exhaust
adaptor
and screws
[] REMOVE FILTER
]_.eulove the shippiug tape holdiug the metal grease
filter in place. Pull down on the center of the fl'ont
edge of the filter. The filter will then slip out of the
retailfing tabs ou the back.
Metal grease filter
[] REVERSE THE BAFFLE FOR
DUCTED INSTALLATIONS ONLY
(JV347, JV348 and JV367 models)
If the hood is to be recirculated, skip to the next step.
Remove the baffle fl'om the top of the hood. Re-install
the baffle so the short side marked "VENTED" is
xisible. The hmg side of the baffle should be inside
the hood.
"VENTED"is visible
[51REIVIOVE WIRING COVER
Remo_e the wiring cover ti'om inside the hood.
Set the cover and its mounting screw aside.
Wiring
[] REMOVE WIRING KNOCKOUT
Reu]oxe either the top or the back wilJng knockout as
needed and install an approxed strain relief clmnp.
Top knockout Back knockout
Strain relief
Strainrelief
clamp
[] REMOVE DUCT KNOCKOUT
If recirculating, uou-\'euted ductless (IN. 2 / aud RN328,
and optional IorJV347,,[V348 and,IV367 models only),
skip to Step 10 D mad proceed.
Usiug a fiat blade screwdlJveI; relnove the approplJate
duct knockout fl'oln the top or back of the hood.
3'/4"x 10"Rectangular
vertical discharge.
Removetop rectangular
ductknockoutonly.
7" Roundvertical
discharge.Removecircular
ductknockoutonly.
3Vd'x 10"Rectangular
horizontal discharge.Remove
rearrectangularductknockoutonly.
10