Manual

www.GEAppliances.com

Possible Causes What To Do

Oven light does not work Light bulb is loose or defective. * Tighten or replace tile bulb.

Plug on range is not completely * Make sure electrical plug is plugged into a live, prol_erly

inserted ha the electrical outlet, grotmded outlet.

Oven will not self-clean The oven temperature is too * ?dlow the range to cool to room temperature and

high to set a self-dema operation, reset the controls.

Oven controls improperly set. * See the Using the self-cleaning oven section.

"Crackling" or This is the sound of the * This is normal.

"popping" sound metal heating and cooling

during both the cooking mad

cleaning functions.

Excessive smoking Excessive soil. * Touch the CLEAR/OFF pad. Open the windows to

rid the room of smoke. X_ait until the LOCKED DOOR

light goes ott. Wipe up the excess soil and reset the

clean cycle.

Oven door will not open Oven too hot. • Allow the oven to cool below locking temperature.

after a clean cycle

Oven not clean after a Oven controls not properly set. * See the Using the self-cleaning oven secti(m.

clean cycle Oven was heavily soiled. * Clean up heavv, spillovers befin'e ,startiw_ the clean

cycle. Heavily soiled ovens may need to sell=clean

again or for a longer period of time.

"tOCK DOOR" flashes The self-clean cycle has been * Close the oven door.

in the display selected but the door is not

closed.

LOCKED DOOR light The oven door is locked * Touch the CLEAR/OFF l)ad. Allow the (),,'ell to cool.

is on when you want because the temperature

to COOk inside the oven has not

dropped below the

locking temperature.

"F--anda number or You have a function error code. * Touch the CLEAR/OFF pad. ?dlow the oven to cool tbr

letter" flash in the display one hotm Put the oven back into ol)eratiou.

If the function code repeats. * Disconnect all power to the range fin" 5 minutes

and then reconnect power. If the flmctiou error

code )'el)eats , call fi)r service.

"Probe"appears in This is remhadhag you to enter a * Enter a probe temperature.

the display probe temperature after plugging

in the probe.