Manual

Installationofthe range.
Read these instructionscompletely and carefully.
[] Installing the Anti-Tip Device
WARNING:
Range must be secured with an approxed
Anti-Tip dexice.
Unless properly installed the range could be
tipped by )ou or a child standing, sitting or
leanino_ on [in ol)en dooI;
Mter installing the Anti-Tip device, xefif}' that
it is in place 1)_ careflfll_ attempting to tilt the
range fin'ward.
This range has been designed to meet all
recognized in(lust_ T tip standards ti)r all
noF/l/al conditions.
The use of this device does not preclude
tipping of the range when not properl)
installed.
If the Anti-Tip dexice supplied with the range
does not fit this al)plication, use the uni',e_al
Anti-Tip dexice _,VB02X7909.
[]
Mark the wall where the RIGHT EDGE of tile
range is to be located. Be sure to allow t0r the
counterto I) overhang ifvou intend to install
the range next to cabinets.
_ devAnti-]iPJ
ice J
,et edbeadsnre ? +--_
./ 21/_" / Markededgeofrange
[] I,ocate the outside edge of the dexice 2½"
toward the center of the range ti'om the
marked edge of the range.
[] Using the device as a template, mark the
position of the hole for the screw.
[] For wood construction, drill a pilot hole at an
angle of 20 degrees fl'om the horizontal, A nail
or awl may be used if a drill is not axailable.
Mount the Anti-Tip device with the screw provided.
For celllent or conci'ete constrtlction, }'oil
will need a 1/4" x 1½" lag bolt and a 1/2" O.D.
sleeve anchor; which are not i)rovided. D_ill
the recommended size hole fin" the hardware.
Wallboard
Backof range
Anti-lip
device
Install the sleeve anchor into the drilled hole and
then install the lag bolt through the device. The
bolts must be i)roperly tightened as recommended
fin" the hardware.
[] Slide tile range against the wall, and check for
prol)er installation l)_, _orasl)ing, the fl'ont edge,
of the cooktop and careflflly attempting to flit
the range forward,
When All Hookups Are Completed:
MAKE SUREALL CONTROLSARE LEFTIN THE
OFFPOSITION.
MAKESURETHEFLOWOFCOMBUSTIONAND
VENTILAtiONAIRTOTHERANGEIS UNOBSTRUCTED.
52
Cofiverting to LP Gas (orconvertingbackto natura/gasfromLP)
Thisrange leavesthe factory set for use with naturalgas.
If you want to convert to LPgas, the conversionmust be
performed by a qualified LPgas installer
Tile comex_ion instructions and I,P orifices can be
tound attached to the range next to the pressure
regulat(n:
Kee I) these instructions and the orifices in case you
want to con'_ert back to nattlI'al gas.