Manual

[] Adjust Broil and Oven Burner Air Adjustment Shutters if NecessarF
Ak adjustmentshuttersforthetopandbottomburners
regulate the flow of air to the flames. LI
f,
The air ac!iustment shutter fi_r the top (broil)
burner is in tile center of tile rear wall of tile oxen.
t° r a* ,s,n nt
Tile shutter fi)r tile bottom (oven) burner is near
the back wall behind the wamfing drawe_; Remoxe
the drawer; See the Care and cleaning of the range
section.
Toadjust the flow of ak to either burner,loosen the Phillips
head screwand rotate the shutter toward open or dosed
position as needed
The flames fi)r the top (broil) burner should be
stea(h with approximatel) l" blue cones and should
not extend out oxer the edges of the burner baffle.
To detemfine if tile bottom burner flames are
burning properly, relllove the oven bottom. Flames
should have approximately 1" blue cones and, if
range is supplied with natural gas, should burn Mth
no yellow tipping. (With most I,P gas, small yellow
tips at the end of outer cones are nomml.) Haines
should not lift off burner ports. If lifting is observed,
gradually reduce air shutter opening until flames
are stabilized.
_?___________/7f-_ / '
To remove the oven bottom:
[] Remoxe tile kmu'led screws holding down
I'eaI" of tile o_,en bottoi//.
] (;rasp tile oven bottom at finger slots on
each side.
] I,ifl tile rear of tile oven bottom enough to
clear tile lip of tile range fl'ame, push it back,
and then pull it up and out.
[] Levering the Range
[] ]nst;fll tile oxen shelxes in tile oxen and
position tile range where it will be installed.
1,!1 m _ Lower
Leg L_¢_ - range
range
(onsomemodels}
Raise_!t °wer
range range
{onsomemodels}
[] Check fi)r levelness by placing a spirit level or
a cup, partiall) filled with water; on one of tile
oxen shelxes. If using a spirit lexel, take two
readings--with tile level placed diagonally
fi_t in one direction and then tile other
] Remove tile wamfing (h'awet: See tile Care
and cleaning of the range secdon. The fi'ont
leveling legs can be a(!iusted fl'om tile bottom
and tile _ear legs can be ac!justed fl'om tile
top or tile bottoI/1,
[] Use an ol)en-end or a(!iustable wrench to
a(!just the lexeling legs until the range is lexel.
[] _Mter the range is lexel, slide the range awa)
fl'om the wall so that the Anti-Tip device can
be installed.
51