User Manual

18 49-40783
Troubleshooting Tips
TROUBLESHOOTING TIPS
Things That Are Normal With Your Microwave Oven
Ŷ Steam or vapor escaping from around
the door.
Ŷ Light reflection around door or outer case.
Ŷ Dimming oven light and change in the blower sound at
power levels other than high.
Ŷ Dull thumping sound while oven is operating.
Ŷ TV/radio interference might be noticed while using the
microwave. Similar to the interference caused by other
small appliances, it does not indicate a problem with the
microwave. Plug the microwave into a different electrical
circuit, move the radio or TV as far away from the
microwave as possible, or check the position and signal
of the TV/radio antenna.
PROBLEM POSSIBLE CAUSE
OVEN WILL NOT COME ON A fuse in your home may be blown or the circuit breaker tripped. Replace fuse or
reset circuit breaker.
Unplug your microwave oven, then plug it back in.
Make sure 3-prong plug on oven is fully inserted into wall receptacle.
CONTROL PANEL
LIGHTED, YET OVEN WILL
NOT START
Door not securely closed.
Start/Pause
must be pressed after entering cooking selection.
Another selection entered already in oven and Cancel/Off not pressed to cancel
it.
Make sure you have entered cooking time after pressing Cook Time.
Cancel/Off was pressed accidentally. Reset cooking program and press Start/
Pause.
Make sure you entered food weight after pressing Defrost Weight.
Oven was paused accidentally. Press Start/Pause to restart the cooking program.
“LOC” APPEARS ON
DISPLAY
The control panel has been locked. (When the control panel is locked, “LOC”
will be displayed.) Press and hold Cancel/Off for about 3 seconds to unlock the
control panel.
“FOOD” APPEARS ON
DISPLAY
The control detected that the door has not been opened (food/beverage has not
been placed inside).
“PF” APPEARS ON
DISPLAY
A Power Failure has occurred. Press Cancel/Off to clear the display.
“F3” APPEARS ON
DISPLAY
A key has been activated for more than 60 seconds. Press Cancel/Off to clear
the display. This can happen if liquid is on the control panel. Dry the control panel
thoroughly after cleaning.